Thermal Safety Device in Main Body

PREPARATIONS BEFORE USE

WINDING THE POWER CORD

1Hook the power cord over the clip which is located on the upper cord storage hook as shown.

Plug Side

2Wind the power cord around the cord storage hooks.

Secure the power cord plug on the power cord.

Cord Storage

Hooks

Clip

To protect your vacuum cleaner motor from overheating, a thermal safety device has been built in. If your vacuum cleaner hose or air intake clogs up with dust or dirt, or if your dust bag becomes full and you continue to run the machine, the vacuum will shut off automatically to prevent the motor from overheating. If this happens, turn off slide switch and disconnect your vacuum from power outlet, remove the material clogging the machine and let your vacuum cool down for approximately 20 minutes. You can then restart your vacuum cleaner and use it again.

INSERTING THE POWER CORD PLUG

WARNING: This appliance is equipped with a grounded-type 3-wire cord (3-prong plug). This plug will only fit into an electrical outlet made for a 3-prong plug. This is a safety feature. If the plug should fail to fit the outlet, contact an electrician to replace the outlet. Do not attempt to defeat the safety purpose of the grounding pin, part of the 3-prong plug.