Removing / Cleaning the IFD Filter

035-00456-000_R0 60000 10/7/03 12:34 PM Page 3

To remove the IFD filter:

•Turn the Control Knob to the OFF position and UNPLUG the air purifier.

•Pull the notch to release the rear grille (Fig. 4).

•Remove the rear grille.

•Gently pull the IFD Filter out of its housing by grasping the center of the filter and pulling towards you (Fig. 5).

To clean the IFD filter:

•DO NOT USE WATER OR OTHER LIQUIDS TO CLEAN THE IFD FILTER.

•After removing the IFD Filter from the air purifier, gently tap the filter onto a firm surface within a trash receptacle to release the captured particles.

•To vacuum-clean the filter, lay the filter on a flat surface and run a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up dirt (Fig. 6).

Fig. 4

Fig. 5

Fig. 6

Vacuum

Attachment

If the IFD Filter clogs or you have difficulty cleaning the filter, please visit our website at www.kaz.com or call us at 1-800-332-1110.

CLEANING THE PRE-FILTER

The particle pre-filter helps pick-up large airborne particles that enter the rear grille. This pre-filter can be removed and rinsed by hand under warm water. Let the pre-filter dry completely before inserting it back into the unit.

INSTALLING THE FILTERS
Please make certain that the Control	Fig. 3	Pre-Filter
Knob is in the OFF position and the air	IFD Filter	Pre-Filter
Knob is in the OFF position and the air
purifier is unplugged.

To install the IFD Filter and pre-filter:

• Hold the filter with the top arrows pointing up ( ) and the insert arrows pointing towards the unit( ) (Fig. 3).

•Gently insert the filter into the filter compartment.

• Make certain that the filter is secure in the unit.

• Place the pre-filter inside the rear grille and snap into place.