2.14 Initialising the VPS During Installation
2.14 Initialising the VPS During Installation
Before programming the VPS for the first time, perform the initialisation procedure described below. All settings are reset to their default values. Recorded messages are erased. System Prompts (including customised prompts) are preserved.
1.Turn the power switch to the off position.
2.Set the Mode Switch to position 5 (see 2.3 Names and Locations).
1 2 3 4
0
1
3.Turn the power switch to the on position.
4.Confirm that the Run Indicator blinks 5 times.
•This may take several minutes. The Alarm Indicator and Run Indicator will first blink intermittently before the Run Indicator blinks 5 times.
5.Turn the power switch off at the VPS.
6.Set the Mode Switch to position 0.
12 3 4
0
1
7.Turn the power switch back on at the VPS.
CAUTION
If the Mode Switch is not set to position 0, all programming will be lost when the power is switched off!
After initialising the VPS, continue with the installation procedure and/or begin programming the VPS.
72
