Panasonic KX-TVM50 installation manual KX-TDA Series PBX Programming for DPT Integration

4.2 KX-TDA Series PBX Programming for DPT Integration

4.2KX-TDA Series PBX Programming for DPT Integration

The screen shots shown in this section are for the KX-TDA200. Programming procedures and availability may vary by country/area, software version, etc. Refer to the documentation included with the PBX or consult your dealer for more information.

A group of DPT ports of a KX-TDA series PBX connected to a VPS with DPT Integration is called a "VM (DPT) Group". Each VM (DPT) Group consists of a maximum of 12 ports (24 channels) of the VPS.

Up to 2 VM (DPT) Groups can be assigned for the KX-TDA100/TDA200; 2 VPSs can be connected to a KX-TDA100/200.

Only one VM (DPT) Group can be assigned for the KX-TDA30; in other words, only one VPS can be connected to a KX-TDA30.

Through PBX system programming, you must assign the VM (DPT) Group and the VM (DPT) extension ports that will use DPT Integration.

1.Assignment of VM (DPT) Group

a)Go to the "Groups-VM (DPT) Group-Unit Setting" screen.

b)Assign a floating extension number to the VPS (VM Unit number).

c)Click "Apply" to save the changed data.

Note

•For the KX-TDA100/KX-TDA200, you can use a maximum of 2 VM (DPT) groups (Unit No.1 and Unit No.2).

All of the extension ports in a VM (DPT) group should be connected to the same DHLC card or DLC card.

Note

•The screen shot above is an example of the KX-TDA200.

2.Assignment of VM (DPT) extension ports

Installation Manual

95