Danby DPAC120061 owner manual DRY Dehumidifier Operating Instructions

Page 11

DRY (Dehumidifier) Operating Instructions

NOTE: During dehumidifier mode, the exhaust hoses do not have to be vented out- doors but should remain attached to the unit. The drain hose must be installed during dehumidifying mode, (see ‘Direct Drain Instructions’ on pg. 5).

1)Press the I/O (on/off) key pad to switch on the unit.

2)Press the MODE key until the DRY symbol (Dehumidifying) appears in the display window. Each depression of the MODE key will advance to a different mode setting (Auto-Cool-Dry-Fan).

3)Press the appropriate (TEMP / TIMER ADJ) key to select a relative humidity setting between 35% ~ 90% RH (adjustable in increments of 5%)

For continuous (non-stop) dehumidifier operation: Press the (TEMP / TIMER ADJ) key pad until the symbol “- - “ appears in the display window. NOTE:

The compressor will not cycle off during “continuous” mode.

The set relative humidity level will flash in the display window for approximately 5 seconds then automatically revert back to display room ambient relative humidity conditions. NOTE: The set operating RH level must be programmed within the 5 second (flashing) condition. To view the “set” relative humidity program any time, press either of the TEMP/TIMER ADJ buttons.

NOTE: There is no fan speed adjustment during dehumidifying mode (the fan speed is factory set for “low”).

The blue (RUN) indicator light illuminates indicating dehumidifying mode is operational (there may be a slight delay of 10-30 seconds before the cycle begins, this is normal).

IMPORTANT: The relative humidity setting selected should always be set a few degrees lower than the room ambient relative humidity conditions, to ensure

normal dehumidifying operation. NOTE: it is not recommended to operate your Dehumidifier below temperatures of 15.5°C (60°F) as this could result in icing-up conditions of the evaporator coils, and minimize efficiency.

4)During ‘Dry’ mode when the internal reservoir is full, the unit will alarm (beep) for 20 seconds and the water full red indicator light will illuminate and the water full icon in the control panel will begin to flash continuously . At this time dehumidification will stop immediately. However, the fan motor will continue to operate (this is normal). To return to normal operation:

1.Switch the unit off;

2.Place a pan with a 1.9L (4 pts.) capacity

beneath the lowest drain ports located on

the

bottom rear of the unit (see Fig. D1, pg. 5);

3.Open the drains by unscrewing their drain caps;

4.Wait until all the water inside the internal reservoir is emptied, then reattach the drain

caps;

5.Properly dispose of the water in the pan;

6.Switch the unit on.

It may take 3-5 minutes for the compressor to re-start. This is normal.

10

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Manuel ’UTILISATION Unit Parts Identification Table Of ContentsIntroduction Unit Specifications DPAC120061Power Consumption Suggested Individual Branch Circuit Electrical SpecificationsPower Supply Cord Electric Shock Hazard InstallationEnergy-Saving Tips To return to normal operation Internal Safety FeatureLock tabs into the 2 slots on the top of each Rain Hood AssemblyKey Pad Functions Indicator Lights & Display IconsOperating Instructions Air Conditioning Setting Time of DAY ClockAir Conditioner Operating Instructions cont’d U T I O N During airDRY Dehumidifier Operating Instructions Compressor will not cycle off during continuous modePage Low-Med-High Fan Operating InstructionsFan Auto-Timer InstructionsSetting the AUTO-ON Timer Setting the AUTO-OFF Timer Setting the AUTO-ON Timer cont’dDuring the same program Setting the AUTO-ON & AUTO-OFF timerBatteries should be replaced when Remote Control FeaturesBattery replacement Control ButtonsCool Low-Medium-High Dry Fan Remote Control Operating InstructionsFan Speed Setting Press Check the followingRnal Water Tank Feature Works Remote Control Operating Instructions cont’dRemoval and Cleaning of the Air Filters Care and MaintenanceLimited Product Warranty Identification des pièces de l’appareil Table des matièresConsommation d’énergie Spécifications de l’unité DPAC120061Circuit de distribution individuel suggéré Spécifications électriquesCordon d’alimentation TableauRisque de choc électrique Installation dans la fenêtreSuggestions pour l’économie de l’énergie Pour retourner aux opérations normales Caractéristique de sécurité interneDe 115 volts / 60 Hz avec mise à la terre Assemblage du ImperméableBrancher l’unité dans une prise de courant Afficheurs et Icônes Mode Icônes VentilateurFonctions du bloc de touches Directives d’utilisation du climatiseur Directives d’utilisation du climatiseur suite Directives D’UTILISATION DU Déshumidificateur Drain inférieur Vidage Directe 32F Réglage de la Minuterie EN Marche Auto Réglage de la Minuterie Arrêt Auto RéglagedelaMINUTERIEENMARCHEAUTOsuiteArrêt AUTO. Appuyer sur la touche Minuterie Les piles devraient être remplacées quand Caractéristiques de télécommandeRemplacement des piles Boutons de contrôleRéglage de la température Basse Moyenne HauteVérifiez ce qui suit Frais Ventilateur Sec DifférentRetrait et nettoyage des filtres à air Soins et entretienGarantie Limitée Portable 3 Season Home Comfort Danby yDANBYnb1-800-263-2629 Danby

DPAC120061 specifications

The Danby DPAC120061 is a portable air conditioner that combines convenience and efficiency, making it an ideal solution for cooling individual rooms or small spaces. This versatile unit boasts a cooling capacity of 12,000 BTUs, which is sufficient for areas up to 450 square feet, ensuring that you stay comfortable even during the hottest months of the year.

One of the standout features of the Danby DPAC120061 is its portability. Equipped with caster wheels and ergonomic handles, this air conditioner can be easily moved from room to room. The included window installation kit further enhances its convenience, allowing users to set it up quickly in various areas of the home without the need for professional installation.

The DPAC120061 is designed with a user-friendly interface, featuring an easy-to-read LED display and remote control that allows users to adjust settings from a distance. It offers multiple cooling and fan speeds, as well as a dehumidification mode that can remove up to 71 pints of moisture from the air per day, helping to improve indoor air quality and comfort.

In terms of energy efficiency, the Danby DPAC120061 is equipped with an eco-friendly refrigerant, R32, which has a lower environmental impact compared to traditional refrigerants. It is Energy Star certified, meaning it meets strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only helps reduce energy bills but also makes it a more environmentally responsible choice for consumers.

The built-in programmable timer allows users to set the unit to turn on or off at specific times, further enhancing its energy-saving capabilities. Users can also utilize the quiet mode for nighttime operation, ensuring a restful sleep without disruptive noise.

In summary, the Danby DPAC120061 portable air conditioner is an excellent choice for anyone looking for an effective cooling solution. With its robust performance, portability, user-friendly controls, and energy-efficient design, it meets the needs of modern consumers who value comfort and convenience in their indoor environments. Whether for a living room, bedroom, or office, this unit is adept at maintaining a pleasant atmosphere all summer long.
Top Page Image Contents