Danby DPAC120061 owner manual Remote Control Operating Instructions, Check the following

Page 18

Remote Control Operating

Instructions

1.Sending Signal: The remote control must be aimed directly at the infra-red eye located below control panel when initiating a command. When the remote control is switched on and a button is pressed, a beep will sound (main unit) confirming a signal was sent/received. All program selections appearing in the remote control display will appear in the display of the main unit when both units are operational. If the main unit does not respond to the command issued, try the procedure again.

If the main unit again fails to respond;

Check the following:

•Are the receiver and the remote unit within the required 7 meter (23 ft.) operating distance?

•Is the receiver window on the main unit partially blocked and/or obscured?

•Are the batteries correctly installed inside the remote (positive+ / negative-)?

•Check the batteries. If low, replace.

2.Setting/Adjusting Time of Day Clock (Remote Control): When the batteries are first installed, the clock display flashes “0:00”. Press the M (minute) button to set the correct time in minutes. Each time the M button is pressed the time is increased in 10 minute increments. The time sets automatically (stops flashing) after 5 seconds. Press/hold the H (hour) button to select/change the correct hour time. (time flashes) Each time the H button is pressed the time will increase in 1 hour increments. The time automatically sets (stops flashing) after 5 seconds. When the main unit is swithed on using the remote control, the time on the main unit will automatically adjust to the time set on the remote control.

3.Mode Setting: Press the “Mode” button to select operating mode. Each time the button is pressed will advance to a different setting i.e Auto–Cool–Dry–Fan.

MODE ICONS

COOL FAN DRY

4.Temperature Setting: Press the remote buttons to select the desired C/F operating temperature.

Each time a button is pressed the temperature will increase/decrease 1°C/F. The temperature selected will appear in the remote display.

When the main unit is switched on using the remote control, the temperature on the main unit will automatically adjust to the temperature set on the remote control. Temperature ranges from 16°C-31°C (60.8°F ~ 88°F)

5.Fan Speed Setting: Press the

“Fan” button to select the operating fan speed. Depending on the mode selection, the fan button will advance to a different fan speed (Auto–Low–Medium –High)

The fan speed selected will appear in the display window.

FAN SPEED ICONS

LOW

MEDIUM

HIGH

 

 

MODE

AVAILABLE FAN SPEEDS

Cool

Low–Medium–High

 

Dry

Low

 

Fan

Low-Medium-High

 

AUTO

Low–Medium–High

 

LCD Window

3

6

Timer On/Off

17

Page 17 Page 19
Image 18
Page 17 Page 19
Contents Manuel ’UTILISATION Table Of Contents Unit Parts IdentificationUnit Specifications DPAC120061 Power ConsumptionIntroduction Electrical Specifications Power Supply CordSuggested Individual Branch Circuit Installation Energy-Saving TipsElectric Shock Hazard Internal Safety Feature To return to normal operationRain Hood Assembly Lock tabs into the 2 slots on the top of eachIndicator Lights & Display Icons Key Pad FunctionsSetting Time of DAY Clock Operating Instructions Air ConditioningU T I O N During air Air Conditioner Operating Instructions cont’dCompressor will not cycle off during continuous mode DRY Dehumidifier Operating InstructionsPage Fan Operating Instructions Low-Med-HighAuto-Timer Instructions Setting the AUTO-ON TimerFan Setting the AUTO-ON Timer cont’d Setting the AUTO-OFF TimerSetting the AUTO-ON & AUTO-OFF timer During the same programControl Buttons Remote Control FeaturesBattery replacement Batteries should be replaced whenCheck the following Remote Control Operating InstructionsFan Speed Setting Press Cool Low-Medium-High Dry FanRemote Control Operating Instructions cont’d Rnal Water Tank Feature WorksCare and Maintenance Removal and Cleaning of the Air FiltersLimited Product Warranty Table des matières Identification des pièces de l’appareilSpécifications de l’unité DPAC120061 Consommation d’énergieTableau Spécifications électriquesCordon d’alimentation Circuit de distribution individuel suggéréInstallation dans la fenêtre Suggestions pour l’économie de l’énergieRisque de choc électrique Caractéristique de sécurité interne Pour retourner aux opérations normalesAssemblage du Imperméable Brancher l’unité dans une prise de courantDe 115 volts / 60 Hz avec mise à la terre Mode Icônes Ventilateur Fonctions du bloc de touchesAfficheurs et Icônes Directives d’utilisation du climatiseur Directives d’utilisation du climatiseur suite Directives D’UTILISATION DU Déshumidificateur Drain inférieur Vidage Directe 32F Réglage de la Minuterie EN Marche Auto RéglagedelaMINUTERIEENMARCHEAUTOsuite Réglage de la Minuterie Arrêt AutoArrêt AUTO. Appuyer sur la touche Minuterie Boutons de contrôle Caractéristiques de télécommandeRemplacement des piles Les piles devraient être remplacées quandFrais Ventilateur Sec Différent Basse Moyenne HauteVérifiez ce qui suit Réglage de la températureSoins et entretien Retrait et nettoyage des filtres à airGarantie Limitée Danby Danby yDANBYnb1-800-263-2629 Portable 3 Season Home Comfort

DPAC120061 specifications

The Danby DPAC120061 is a portable air conditioner that combines convenience and efficiency, making it an ideal solution for cooling individual rooms or small spaces. This versatile unit boasts a cooling capacity of 12,000 BTUs, which is sufficient for areas up to 450 square feet, ensuring that you stay comfortable even during the hottest months of the year.

One of the standout features of the Danby DPAC120061 is its portability. Equipped with caster wheels and ergonomic handles, this air conditioner can be easily moved from room to room. The included window installation kit further enhances its convenience, allowing users to set it up quickly in various areas of the home without the need for professional installation.

The DPAC120061 is designed with a user-friendly interface, featuring an easy-to-read LED display and remote control that allows users to adjust settings from a distance. It offers multiple cooling and fan speeds, as well as a dehumidification mode that can remove up to 71 pints of moisture from the air per day, helping to improve indoor air quality and comfort.

In terms of energy efficiency, the Danby DPAC120061 is equipped with an eco-friendly refrigerant, R32, which has a lower environmental impact compared to traditional refrigerants. It is Energy Star certified, meaning it meets strict energy efficiency guidelines set by the U.S. Environmental Protection Agency. This not only helps reduce energy bills but also makes it a more environmentally responsible choice for consumers.

The built-in programmable timer allows users to set the unit to turn on or off at specific times, further enhancing its energy-saving capabilities. Users can also utilize the quiet mode for nighttime operation, ensuring a restful sleep without disruptive noise.

In summary, the Danby DPAC120061 portable air conditioner is an excellent choice for anyone looking for an effective cooling solution. With its robust performance, portability, user-friendly controls, and energy-efficient design, it meets the needs of modern consumers who value comfort and convenience in their indoor environments. Whether for a living room, bedroom, or office, this unit is adept at maintaining a pleasant atmosphere all summer long.
Top Page Image Contents