TDK NX-7CD manual Clock/Timer, Clock setting, Timer setting, Sleep timer setting

CLOCK/TIMER

Clock setting

1.In standby mode, press and hold MEM/ CLK SET, “12HOUR” or “24HOUR” is

displayed and flashing. Press or to change the hour mode.

2.Press MEM/CLK SET, the clock digits

for the hours flash. Press or to set the hours.

3.Press MEM/CLK SET, the clock digits for the minutes flash. Press to set the minutes.

4.PressMEM/CLK SET to confirm the time.

Timer setting

The timer enables the system to switch on and off in CD or Tuner mode at the specified time as an alarm clock. The clock time needs to be set first before the timer can beused.

1.Press and hold TIMER on remote control until “TIMER” and “ON” are displayed. The clock digits for the hours

flash. Press or to set the hours of ON time

2.Press TIMER on remote control. The clock digits for the minutes flash. Press or to set the minutes of ON time.

3.Press TIMER on remote control. “TIMER” and “OFF” are displayed and the clock digits for the hours flash. Press or to set the hours of OFF time.

4.Press TIMER on remote control. The clock digits for the minutes flash. Press or to set the minutes of OFF time.

5.Press TIMER on remote control. “TUNER” or “CD” is displayed. Press or to select your desired source which will be started at the set time.

6.Press TIMER on remote control, “VOL

XX” is displayed. Press or to adjust the volume level.

7.Press TIMER on remote control to confirm the timer.

Press TIMER once on remote control. Display shows “TIMER” if activated and disappears if deactivated.

Note:

•When the OFF time is same as the ON time, display shows “ERROR”and then returns to timer setting for revising the OFF time. In this case do not press the timer button for several seconds to let the timer setting mode return to normal. Then, you can re-enter new timer start from step 1.

•If you selected CD mode for the source of timer ON, a CD/MP3-CD disc must be loaded into the system. In case you forget to load a CD/MP3-CD disc into the CD compartment. The system will also turn on at the specified time but will change to Tuner mode automatically.

Sleep timer setting

The sleep timer enables the system to switch off by itself after a set period of time.

1.Press SLEEP on remote control repeatedly to select a preset time. The selections from 90 to 10 minutes, decreasing in 10 minute increments.

2.Once the sleep time is selected, “SLEEP” and the selected time appear constant on the display.

3.To deactivate the sleep timer, press SLEEP repeatedly on remote control until “SLEEP” and timer goes off.

7