Connecting the TUN-3.7, Before Making Any Connections

Connecting the TUN-3.7

Before Making Any Connections

•Refer to the instructions that came with the com- ponent you are connecting.

•Do not plug in the power cord until all other con- nections are complete.

•Do not bind audio cables with power cords and speaker cables. Doing so may adversely affect the sound quality.

•To prevent interference, keep power cords and speaker cables as far away as possible from the antennas.

RCA Audio Connection Color Coding

•Red plugs are used for the right channel, white plugs are used for the left channel.

Left (white)	L
Right (red)	R

•Push each plug in all the way to make a good con- nection (loose connections can cause noise or mal- functions).

Right!

Wrong!

Connecting to an Ampliﬁer

Use the supplied audio cable to connect the TUN-3.7’s AUDIO OUTPUT L/R jacks to the TUNER IN jacks on your ampliﬁer, as shown.

To use the system functions, use the supplied

cable to make an connection (see the next column).

TUN-3.7

Supplied audio

cable	Supplied	cable

TUNER

Ampliﬁer

Note:

•If the TUN-3.7 is used with another Integra/Onkyo component, refer to its instruction manual as well.

About the System Functions

If you connect the TUN-3.7 to another Integra/Onkyo

-capable component with the supplied cable and audio cable, you can use the following system func-

tions. cables are special cables solely for use with Integra/Onkyo products.

Auto Power On

When you turn on the TUN-3.7, your Integra/Onkyo ampliﬁer or receiver will turn on automatically. (The ampliﬁer’s POWER switch must be set to ON for this to work.)

Direct Change

When you select a radio preset or change the band (AM, FM, etc.), your Integra/Onkyo ampliﬁer will automati- cally select the TUN-3.7 as the input source.

Remote Control Operation

You can control the TUN-3.7 by using your Inte- gra/Onkyo ampliﬁer or receiver’s remote controller. See the ampliﬁer or receiver’s instruction manual for details.