Integra DPC-7.5 instruction manual Controls & Connectors Rear Panel, Ir In/Out

Controls & Connectors—Continued

Rear Panel

1 2 3 4

	VIDEO OUTPUT
	COMPONENT 2
Y	PB		PR
	COMPONENT 1			AUDIO OUTPUT		RS 232
				DIGITAL
Y	PB	PR	S VIDEO	OPTICAL	COAXIAL
AUDIO OUTPUT
	ANALOG		VIDEO
	L		IN
			IR
	R		OUT	REMOTE
				CONTROL

5 6 7 89 J

DVD CHANGER

MODEL NO. DPC-7.5

AC INLET

K

For detailed information, refer to the pages in parenthesis.

ACOMPONENT 1 VIDEO OUTPUT (17)

These RCA/phono connectors can be used to connect a TV or projector with RCA/phono component video inputs.

The DPC-7.5 has two component video outputs, the COMPONENT 1 and COMPONENT 2, however, they output the same video signal.

BCOMPONENT 2 VIDEO OUTPUT (17)

These BNC connectors can be used to connect a TV or projector with BNC component video inputs.

The DPC-7.5 has two component video outputs, the COMPONENT 1 and COMPONENT 2, however, they output the same video signal.

CS VIDEO OUTPUT (17)

These connectors can be used to connect TVs or projec- tors with S-Video inputs.

The DPC-7.5 has two S-Video output connectors. They output the same video signal.

DVIDEO OUTPUT (17)

These RCA/phono connectors can be used to connect TVs or projectors with composite video inputs.

The DPC-7.5 has two composite video output connec- tors. They output the same video signal respectively.

EANALOG AUDIO OUTPUT (17, 18)

These RCA/phono connectors can be connected to the analog audio inputs on your TV, hi-fi amp, AV receiver, or surround sound decoder (Dolby Pro Logic). There are two sets of outputs.You could connect one set to your AV receiver, the other to your TV for those occasions when you want to watch a DVD-Video but don’t want to use your AV receiver.

The DPC-7.5 has two pairs of stereo analog audio output connectors. They output the same audio signal respec- tively.

FIR IN/OUT (20)

The IR IN connector can be used to connect a commer- cially available IR receiver, which can be used to pickup signals from the remote controller when the DPC-7.5 is located in another room, installed in a rack, or is out of range of the remote controller

The IR OUT connector can be used to connect a com- mercially available IR emitter, which can be used to pass remote controller signals received by the IR IN along to other AV components.

G REMOTE CONTROL (19)

These (Remote Interactive) connectors can be con-

nected to the connectors on your other Integra/ Onkyo AV components for interactive control.

To use you must also make an analog RCA/phono connection between your DPC-7.5 and Integra/Onkyo AV receiver, even if they are connected digitally.

HOPTICAL AUDIO OUTPUT (18)

This optical digital audio output can be connected to an optical digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS).

ICOAXIAL AUDIO OUTPUT (18)

This coaxial digital audio output can be connected to an coaxial digital audio input on a hi-fi amp, AV receiver, or surround sound decoder (Dolby Digital, DTS).

JRS 232

This RS-232 port can be connected to an external con- troller.

KAC INLET (21)

The supplied power cord is connected here. The other end of the power cord should be connected to a suitable wall outlet.

12