Integra DPC-7.5 instruction manual Troubleshooting

Page 47

Troubleshooting—Continued

Symptom

Possible cause

Remedy

 

 

 

 

JPEG files without a “.jpg” or “.JPG” or

 

 

“.JPEG” filename extension are not recog-

Use the correct filename extension (page 8).

 

nized.

 

 

 

 

 

Only Baseline JPEG files are supported.

Use Baseline JPEG files (page 8).

 

Progressive JPEG files are not.

Can’t view JPEG files?

 

 

 

Only JPEG files with the following bright-

 

 

 

 

ness/color difference ratios are supported:

Use JPEG files with the supported ratio (page 8).

 

4:4:4, 4:2:2, and 4:1:1.

 

 

 

 

 

The JPEG file is too big.

Use JPEG files that are less than 5 megabytes

 

(page 8).

 

 

 

 

 

The message “NO

 

 

PLAY” appears on the

The disc is dirty.

Remove the disc and clean it (page 8).

display?

 

 

 

 

 

Buttons on the DPC-7.5

Power supply voltage fluctuations and other

Turn off the DPC-7.5, wait five seconds, then turn

it on again. If that doesn’t resolve the issue, dis-

and remote controller

anomalies, such as static electricity, can

connect the power cord from the wall outlet, wait

don’t work?

interfere with normal operation.

five seconds, reconnect it, then try again.

 

 

 

 

 

 

There are no batteries in the remote

Install new batteries (page 15).

 

controller.

 

 

 

 

 

 

The batteries are flat.

Replace with new batteries (page 15).

 

 

 

 

The batteries are installed incorrectly.

Check the batteries and correct as necessary

 

(page 15).

 

 

 

 

 

 

You’re not pointing the remote controller at

Point the remote controller at the DPC-7.5’s

Buttons on the DPC-7.5

the DPC-7.5’s remote sensor.

remote sensor (page 15).

work OK but those on

 

 

 

Use the remote controller closer to the DPC-7.5

the remote controller

 

You’re too far away from the DPC-7.5.

(page 15). The remote controller has a range of

don’t?

 

approximately 16 ft. (5 meters).

 

 

 

 

 

 

A strong light source is interfering with the

Make sure that the DPC-7.5 is not subjected to

 

direct sunshine or inverter-type fluorescent lights.

 

DPC-7.5’s remote sensor.

 

Relocate if necessary.

 

 

 

 

 

 

If the DPC-7.5 is installed in a cabinet with

 

 

colored glass doors, the remote controller

Open the doors, or use a cabinet without colored

 

may not work reliably when the doors are

glass.

 

closed.

 

 

 

 

Abnormal Behavior

The DPC-7.5 contains a microcomputer for signal processing and control functions. In very rare situations, severe interfer- ence, noise from an external source, or static electricity may cause it to lockup. In the unlikely even that this should happen, unplug the power cord from the wall outlet, wait at least five seconds, and then plug it back in again. Alternatively, press and hold the Stop [] button until “RESET” appears on the display (about 10 seconds).

Restoring the Default Settings

To reset the DPC-7.5 to its factory defaults, turn it on and, while holding down the Stop [] button, press the [Standby/On] button. “INITIALIZE” appears on the display. When the reset is complete, “COMPLETE” is displayed, and the DPC-7.5 enters Standby mode.

47

Image 47
Contents DPC-7.5 Contents Important Safety Instructions Sur les modèles dont la fiche est polarisée PrecautionsFor models having a power cord with a polarized plug Precautions Introduction Supplied AccessoriesDPC-7.5 Features DVD Region Numbers Supported Discs Unsupported DVD FeaturesDisc Content Organization Introduction Disc NotesMP3/WMA/JPEG Compatibility Cleaning DiscsIntroduction Video CDsCopyright DPC-7.5-related TerminologyStoring Discs Front Panel Controls & ConnectorsControls & Connectors Display IR IN/OUT Controls & Connectors Rear PanelControls & Connectors Remote Controller Controls & Connectors Using the Remote Controller Before Using the DPC-7.5Installing the Remote Controller’s Batteries Optical Digital Inputs Connecting the DPC-7.5AV Cables & Connectors Before Making Any ConnectionsLets Connecting the DPC-7.5 Connecting Your TV or ProjectorPowering Up & Setting Up the DPC-7.5 on Turn off the DPC-7.5 and your TV, and disDigital Connection Connecting the DPC-7.5 Connecting Your Hi-Fi AmpConnecting for Dolby Digital or DTS Analog ConnectionPlug the supplied power cord into the AC Inlet Connecting the DPC-7.5 Connecting -compatible AV ComponentsConnect the IR receiver to the DPC-7.5 as shown below Controlling the DPC-7.5 When It’s Out of RangeControlling Other Out-of-range AV Components First Time Setup Powering Up & Setting Up the DPC-7.5Powering Up the DPC-7.5 Loading Discs During Playback Basic PlaybackLoading & Removing Discs Selecting Discs Starting, Pausing & Stopping PlaybackBasic Playback Basic Playback Video CD Navigating Disc MenusTo start playback of the specified Selecting Titles & Chapters by NumberUse the number buttons to specify a chapter or title Press the Play or Enter buttonUsing the Disc Navigator To start memory playback, press the Play button Basic Playback Memory Playback in the Disc NavigatorWith the Disc Navigator open, press the Memory button Playlist appears in place of the file informationFast Forward & Reverse Selecting Tracks by NumberFrame-by-Frame Playback Adjusting the Display BrightnessSlow-motion Playback Using Chain Mode Using Jpeg CDsRepeat Playback Advanced PlaybackLocating Specific Points in Time Random Playback Advanced PlaybackMemory Playback Selecting Camera Angles Remote controller window, press the Memory butSelecting Subtitles Using Progressive ScanningSelecting Languages & Audio Formats Display Stop Using Last MemoryDuring playback, press the Last M button Last Memory dialog box appears, as shownPress the Display button again to Cancel the information displayAdvanced Playback Displaying Information During playback, press the DisConfiguring the DPC-7.5 Menu Setting Description PictureTV Shape Using the Onscreen Setup MenusConfiguring the DPC-7.5 Picture MenuPAL Output Setting Australian model only Interlaced SettingProgressive Setting Dynamic Range Control Dolby Digital only Configuring the DPC-7.5 Audio MenuLanguage Menu Digital OutDisplay Menu Parental Lock Operation Setting MenuScreen Saver Pause/StillSelecting Other Languages Language Code ListInitial Setup Menu Auto Power OffTroubleshooting Troubleshooting Component Video Specifications