Trion HE Plus 1400, HE Plus 2000 warranty Do not Install the AIR Cleaner in the Discharge AIR Duct

Page 14

Installation

For Qualified HVAC

Installer Only

Application

The air cleaner is used in forced air heating, cooling and ventilating systems. It should be installed in the system such that all the system air is circulated through the air cleaner. The air cleaner will only remove the airborne contaminants delivered to it; maximum performance is obtained with the system blower set for continuous operation.

Installation Requirements

• The best location for the air cleaner is in the return air duct next to

the blower compartment. In this location, the blower motor and

cooling coils will be kept clean.

• DO NOT INSTALL THE AIR CLEANER IN THE DISCHARGE AIR DUCT

Atomizing Humidifiers

If an atomizing humidifier is mounted upstream of the air cleaner:

1.Mount the humidifier as far upstream in the ductwork as possible. A distance of at least 10 feet is recommended to reduce the possibility of excessive arcing as water droplets pass through the Electronic Air Cleaner.

2.Install a standard disposable furnace filter between the humidifier and the air cleaner to trap water droplets and hard water deposits.

3.Clean the air cleaner more frequently to prevent hard water buildup.

Installation

For Qualified HVAC

Installer Only

• Before installing the air cleaner, consider the application and type of

HVAC system present.

• Refer to the Typical Mounting Positions section for the most

common configurations.

• Refer to the Transitions section if a transition is required between

the duct work and the air cleaner.

• The unit must be readily accessible for periodic inspection and

cleaning of the Pre-filters and Ionizing-Collecting Cells to maintain

maximum efficiency and trouble free operation.

Air Conditioning

The air cleaner should be installed upstream of the cooling coil to keep the coil clean and reduce air conditioning coil maintenance. A clean coil will reduce utility costs by maintaining the coil’s efficiency. If the air cleaner is downstream of the cooling coil, condensation will form on the cooled collector plates when the air conditioner cycles. This will allow water droplets to form on the collector plates and cause nuisance arcing in the air cleaner. Arcing will reduce air cleaner efficiency and reduce the life of the high voltage power supply.

Evaporative Humidifiers

An evaporative type humidifier can be mounted either upstream or downstream of the air cleaner, depending upon the desired humidification capacity.

If an atomizing humidifier is mounted downstream of the air cleaner:

No additional considerations required.

Sheet Metal Installation

The Electronic Air Cleaner is adaptable to all new or existing residential forced air furnace and cooling systems.

Transitions

If the air duct does not fit the air cleaner cabinet opening, gradual transitions are recommended to reduce air turbulence through the air cleaner and maximize efficiency. Not more than 20° (about 4” per running foot) of expansion should be used on each side of the transition section.

Outdoor Air

When outdoor air is added to the return air duct, sufficient heat should be added to maintain the return air temperature at 40°F (4° C) minimum. Lower temperatures can cause ionizer wire failure.

Turning Vanes

If the air cleaner is installed adjacent to a 90° duct elbow, add turning vanes inside the duct to improve air distribution across the face of the air cleaner. Failure to follow this recommendation can reduce the efficiency of the Electronic Air Cleaner.

Maximum 4" drop per linear foot

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Air Flow

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

CleanerAir

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Air Flow

 

 

 

 

 

 

opening

 

Furnace opening

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Furnace

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Air Cleaner Transition section

12

13

Image 14
Contents Warranty Electronic AIR Cleaner Limited THREE-YEAR WarrantyTable of Contents Parts ListIntroduction TroubleshootingIntroduction Secondary Circuit Power Supply Unit ComponentsRegular Dusting and White Dust OperationSecondary Circuit IONIZING-COLLECTING Cell OzonePrimary Circuit with Hvac System Blower not Operating High Altitude OperationPrimary Circuit with Hvac System Blower Operating Maintenance Cleaning the AIR Flow Sensor InstallationReplacing the Ionizing Wires System CheckoutGreen Black to Black White to White Electrical InstallationCommon Questions and Answers Blower CompartmentScrews Mounting Holes Physical Installation of the AIR Cleaner InstallationInstaller Help Line SymptomTypical Mounting Positions Unit DimensionsAir cleaner shown shaded in illustrations Location Selection Direction of Airflow Through the AIR CleanerTechnical Specifications For left to right airflowDo not Install the AIR Cleaner in the Discharge AIR Duct