Rose electronic CLK-4U2FM-500M, CLK-4U2FS-10KM FCC/IC STATEMENTS, EU Declaration of Conformity

Page 3

FCC/IC STATEMENTS, EU DECLARATION OF CONFORMITY

FEDERAL COMMUNICATIONS COMMISSION

AND INDUSTRY CANADA

RADIO-FREQUENCY INTERFERENCE STATEMENTS

This equipment generates, uses and can radiate radio frequency energy and if not installed and used properly, that is in strict accordance with the manufacturer’s instructions may cause interference to radio communication. It has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications of Part 15 of FCC rules, which are designed to provide reasonable protection against such interference when the equipment is operated in a commercial environment. Operation of this equipment in a residential area is likely to cause interference, in which case the user at his own expense will be required to take whatever measures may be necessary to correct the interference.

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment. This digital apparatus does not exceed the Class B limits for radio noise emission from digital apparatus set out in the Radio Interference Regulation of Industry Canada.

Le présent appareil numérique n’émet pas de bruits radioélectriques dépassant les limites applicables aux appareils numériques de la classe B prescrites dans le Règlement sur le brouillage radioélectrique publié par Industrie Canada.

EUROPEAN UNION DECLARATION OF CONFORMITY

The Declaration of Conformity is based upon compliance of the product with the following harmonized standards:

EN55022+A1

2007 Class B

EN61000-3-2

2006

EN61000-3-3

2003

EN55024

1998+A2:2003

IC Statement

This Class B digital apparatus complies with Canadian ICES-003

Image 3
Contents Installation Operations Manual Limited Warranty FCC/IC STATEMENTS, EU Declaration of Conformity Table of Contents System introduction DisclaimerFeatures Package contentsRose Electronics web site About this manual Indicator LEDs ConnectorsCrystalLink USB 2.0 Fiber model Receiver Troubleshooting Operating Instructions SafetyHost LED on the transmitter is off Troubleshooting GuideAll LEDs on the transmitter or receiver are off Link LEDs on the transmitter and receiver are both offSafety Safety and EMC Regulatory Statements GroundingServicing Service Information ServiceUse only the AC adapter provided Appendix A. General SpecificationsAppendices Appendix B. Part Numbers and CablesStancliff Road Houston, Texas Phone 281