Simplicity 8/25, 6/25 manual Troubleshooting & Repair

Troubleshooting & Repair

Figure 20.	Pull Drive Pulley Bearing Plate And Slide	Figure 21. Pull Drive Pulley Bearing Plate Assembly
Drive Belt	Off Pulley	Out Of Vacuum Nozzle Housing

Figure 22. Remove Vacuum Nozzle Housing Nuts	Figure 23. Pull Off Safety Interlock Wire At
	Spade Terminal

5.Pull the drive pulley bearing plate straight out, and lift the drive belt off the pulley to permit complete removal of the plate assembly (Figure 20). It may be necessary to tap the plate with a hammer to help free it from the splined hub assembly on the rotor.

6.Continue pulling the drive pulley bearing plate straight out, and remove it from the vacuum nozzle housing. Note that the shaft end is splined to mate with the splined hub assembly on the rqtor (Figure

21).

7.Using a i/2” socket wrench, remove the (4) 5116-18 hex nuts that secure the vacuum nozzle housing to the shredder housing (Figure 22).

8.Remove the safety interlock leads from the spade terminal (Figure 23), and engine block base (Figure

24). A l/2” socket and i/2” box wrench are required Figure 24. Remove Hex Nut And Screw Securing

to remove the hex nut and hex head screw. Safety Interlock Wire #2 To Engine Block Base

2 6