4.See figure 52. Reattach the rod to the front axle with the clip.
NOTE: Changing the rod length will affect the ground clearance measurement at all height ranges and may be used to make fine adjustments to the nozzle height at any position desired.
CLUTCH CABLE
The clutch cable does not require service. If the clutch cable should become detached from the clutch lever, fol- low these steps:
1.Remove the vacuum nozzle housing as illustrated in the hammer service section of this manual.
2.The clutch lever is located directly in front of the transmission.
3.To reattach the clutch cable to the clutch lever, push the clutch lever back with one hand, and insert the cable end into the hole in the lever (Figure 54).
4.When properly inserted, the clutch cable end hook will be seated at the second bend in the hook (Figure 55).
5.With the unit turned off, check the clutch lever for proper operation by operating the power drive bail lever. Make sure that there is no slack in the clutch cable when the bail lever is fully depressed against the handle of the unit. If the cable is slack, release the bail lever and move the spring end down one link on the chain connector, and recheck for tautness. Adjust tension until clutch cable is taut when bail lever is depressed (Figure 56).
6.Reassemble the unit in the reverse sequence used for disassembly.
Figure 54. Push Clutch Lever And Reinsert Cable End
Figure 55. Proper Clutch Cable Position On Clutch Lever
L‘2759T
L Attachment
Figure 56. Clutc :h 
C
3 5