Smith Cast Iron Boilers JW317, JWF507, JW727 manual HOW the Original Owner can Make a Warranty Claim

Page 25

d.The water heater or any of its component parts are damaged or fails from operation with an empty or partially empty tank (such as, but not limited to elements burned out in a dry tank); or

e.The water heater or any part has been under water; or

f.The water heater is exposed to highly corrosive atmospheric conditions. No warranty extends, for example, and without limitation of the foregoing, to Units exposed to: salts, chemicals, exhausts, pollutants or contaminants; or

g.The water heater is not continuously supplied with potable water; or

h.The water heater replacement is requested for reasons of noise, taste, odor, discoloration and/or rust; or

i.The water heater is operated at temperatures exceeding the maximum setting of the thermostat and/or high limit control provided by the Manufacturer, or at water pressures exceeding the pressure reading stated on the Unit; or

j.The water heater is operated without an operating anode; or

k.The water heater is supplied or operated with deionized water; or

l.The water heater is removed from its original installation location; or

m.The water heater is installed outdoors (this water heater is intended only for indoor installation); or

n.The water heater is converted, or is attempted to be converted, from one voltage or wattage to another, if an elec- tric water heater, or from one type gas to another, if a gas water heater; or

o.The water heater has not been fired at the factory rated input and fuel for which it was factory built; or

p.The water heater or any of its component parts fail due to sediment build-up; or

q.The water heater does not have installed a properly operating temperature and pressure relief valve, certified to ANSI Z21.22/CSA “Requirements for Relief Valves for Hot Water Supply Systems”; or

r.The water heater or any of its component parts fail because of fire, floods, lightening, or any other act of God, or any other contingency beyond the control of the Manufacturer; or

s.The water heater is installed in a closed system without adequate provision for thermal expansion.

3.Except when specifically prohibited by the applicable law, the Owner, and not the Manufacturer, shall be liable for and shall pay for all charges for labour or other expenses incurred in the removal, repair or replacement of the water heater or any component part(s) claimed to be defective or any expense incurred to remedy any defect in the product. Such charges may include, but are not necessarily limited to:

a.All freight, shipping, handling and delivery costs of forwarding a new water heater or replacement part(s) to the Owner.

b.All costs necessary or incidental in removing the defective water heater or component part(s) and installing a new water heater or component part(s).

c.Any material required to complete, and/or permits required for, installation of a new water heater or replacement part(s), and

d.All costs necessary or incidental in returning the defective water heater or component part(s) to a location desig- nated by the Manufacturer.

4.The terms of this Limited Warranty cannot be modified by any person, whether or not he/she claims to represent or act on behalf of the Manufacturer.

E.HOW THE ORIGINAL OWNER CAN MAKE A WARRANTY CLAIM.

1.The Owner should submit the warranty claim directly to Manufacturer’s Service Department, at the address or phone number listed below, and Manufacturer will arrange for the handling of the claim.

2.Whenever any inquiry or request is made, be sure to include the water heater’s catalogue number, model number, ser- ial number, date of purchase, date of installation, and location of installation.

This warranty and the Manufacturer’s obligations shall be construed and determined in accordance with the laws of both the Province of Ontario, and of Canada in force therein. This Warranty does not affect specific legal rights of a consumer under applicable law, except to the extent that such rights may be waived or replaced, and the provisions hereof are deemed to be amended to the extent necessary. The unenforceability of any provision, in whole or in part, of this Certificate shall not affect the remaining provisions. Any and all repair and/or replacement of part(s) or Unit are the sole and exclusive remedy available against the Manufacturer.

GSW Water Heating

599 Hill Street West

Fergus, ON Canada N1M 2X1

Should you have any questions please Email us at techsupport@gsw-wh.com or Visit our websites: www.gsw-wh.com or www.johnwoodwaterheaters.com or Call our Technical Support line at 1-888-GSW-TECH (479-8324)

GSW Water Heating is a division of A.O.Smith Enterprises Ltd.

– 25 –

Page 24 Page 26
Image 25
Page 24 Page 26
Contents What to do if YOU Smell OIL For Your SafetyImmediately call your oil supplier Table of Contents For Installations in Canada II SafetyIntroduction Consumer ResponsibilitiesSafety Warning Flammable Vapours For Installations in the United StatesSafety Warning Scalding Relief Valve Requirements T&PLocation Requirements Oil Supply Clearances and AccessibilityEarthquake Zones JWF307V Installation Dimensions Center Flue Models Air Requirements Where the water heater is locatedAir Supply Ducted Furnace Room And/or roomVent and Exhaust Connections Power Venting Blocked Vent Safety SwitchWater Supply Plumbing Connections Center Flue Filling the Water HeaterVacuum Relief Valves Temperature and Pressure Relief ValveClosed System/Thermal Expansion Discharge Line/DriptubeElectrical Supply Installation Of The Aquastat Temperature Control48245 Water Temperature Regulation Installation ChecklistIV Operation Water Heater Sounds Anode MaintenanceSmoke/Odour Anode Rod/Water OdourMaintenance Re-Starting The Heater After Shut- Down Shut Down For Extended PeriodsVI Combo Heating Combo Heating Baseboard InstallationVII OIL Burner Listing Beckett AFG GSW-J5006 WHO is Covered Limited WarrantyHOW the Original Owner can Make a Warranty Claim

JW327, JW517, JWF307V, JWF657, JWF507 specifications

Smith Cast Iron Boilers have established a strong reputation in the heating industry for their durable, efficient, and reliable products. Among their notable models are the JWF507, JW717, JWF657, JW327, and JW517. Each of these models incorporates advanced technologies and unique features tailored to meet various heating demands.

The JWF507 is renowned for its exceptional thermal efficiency. This boiler utilizes a water-to-water heat exchanger, providing efficient heat transfer, which significantly reduces fuel consumption. Its robust cast iron construction ensures longevity, even in harsh conditions, while an oversized heat exchanger design enhances performance and reliability.

The JW717 model stands out with its ability to handle large-scale heating needs. This boiler features a multi-pass design that maximizes heat transfer and minimizes the chance of overheating. Additionally, it is equipped with an advanced control system that allows for precise temperature adjustments, ensuring optimal comfort in residential and commercial settings.

The JWF657 introduces a unique burner design, which improves combustion efficiency and reduces emissions. This model also features a built-in pump which enhances the system's circulation, helping to maintain consistent and comfortable heating throughout the space. With its energy-efficient attributes, the JWF657 is a top choice for environmentally-conscious consumers.

Next in line, the JW327 model is designed for versatility and adaptability. This boiler can easily be integrated into various heating systems, making it suitable for both retrofit and new construction projects. Its compact size allows for easy installation in tight spaces, while its high-efficiency rating contributes to lower energy bills.

Lastly, the JW517 model is known for its reliability and user-friendly design. This boiler is equipped with an intuitive control panel, making operation simple and straightforward. Its rugged cast iron construction is designed to withstand rigorous use, providing peace of mind for users who seek a dependable heating solution.

In summary, Smith Cast Iron Boilers offer a diverse portfolio with models like the JWF507, JW717, JWF657, JW327, and JW517, each boasting unique features and technologies. From high thermal efficiency and advanced combustion systems to user-friendly designs and rugged durability, these boilers are crafted to deliver optimal performance in various heating applications. Whether for residential or commercial use, these models exemplify the superior quality and innovation that Smith Cast Iron Boilers is known for.
Top Page Image Contents