Woods Equipment manual General Information, Specifications, PICK-UP Brooms, PB600-2 PB720-2

Page 4

GENERAL INFORMATION

The purpose of this manual is to assist you in oper- ating and maintaining your pick-up broom. Read it carefully. The information and instructions will help you achieve years of dependable performance. These instructions have been compiled from exten- sive field experience and engineering data. Some information may be general in nature due to unknown and varying operating conditions. How- ever, through experience and these instructions, you should be able to develop procedures suitable to your particular situation.

The illustrations and data used in this manual were cur- rent at the time of printing, but due to possible inline production changes, your pick-up broom may vary slightly in detail. We reserve the right to redesign and change the pick-up broom as may be necessary, with- out notification.

Throughout this manual, references are made to right and left directions. These are determined by standing behind the equipment facing the direction of forward travel.

SPECIFICATIONS

PICK-UP BROOMS

 

PB600-2

PB720-2

Overall length

57 inches

57 inches

Overall width

66.6 inches

78.6 inches

Flow requirements

12 - 25 gpm

12 - 25 gpm

Maximum hydraulic oil pressure

3000 psi

3000 psi

Operating weight

817 lbs

925 lbs

Single gutter broom weight

75 lbs

75 lbs

4 Introduction

MAN0661 (8/10/2007)

 

 

Image 4
Contents PICK-UP Broom Introduction To the DealerTable of Contents LEA EL InstructivoSpecifications General InformationPICK-UP Brooms PB600-2 PB720-2Safety Safety RulesInstallation TrainingOperation Maintenance StorageSafety & Instructional Decals Be Careful Falling OFF can Result in Being RUN OverOperation OperationAttach Broom to Skid Steer Adjustment Check Brush PatternAdjust Brush Height Adjust Flaps and Plate ShieldSweeping Operating tipsDumping Loads TransportingGutter Brush Optional Adjust Gutter Brush Swing Adjust Gutter Brush HeightReplace the Gutter Brush Remove Broom from Skid Steer PRE-OPERATION Check ListOwner Service Owner ServiceMaintenance Procedure Daily HoursAfter Each Use CleaningPeriodically or Before Extended Storage Troubleshooting TroubleshootingTroubleshooting Dealer Service Dealer ServiceInstall New Sections Replace Brush SectionsAssemble Unit Dealer Check Lists Dealer Check ListsPRE-DELIVERY Check List Delivery Check ListAssembly Assembly InstructionsInstall Gutter Brush Optional Install Hydraulic HosesRight Gutter Brush Installation PB600-2 & PB720-2 PICK-UP Broom Assembly PartsCore Assembly Part QTY DescriptionMotor Assembly Hood Assembly Hopper Assembly Gutter Brush Assembly Optional Gutter Brush Assembly Parts List Optional Quick Coupler Quick Coupler KitsQuick Coupler KIT Components QC Kit DescriptionQuick Coupler Set Appendix Fitting Torque ChartTorque SAE Series Torque Chart Bolt Torque ChartMetric Series Torque Chart Bolt Size Chart AbbreviationsWarranty Rev /23/2005 MAN0661