Start the broom at a low speed; then, lower it so the bristle tips touch the ground. Run the broom in a sta- tionary position for ten seconds.
Raise the broom and back away. Switch off the engine and remove the key. The brush pattern left in the dust should be two to four inches wide, running the length of the brush. See Figure 4.
Figure 3. Back of Attachment - Slot Locations
ADJUSTMENT
Before leaving operator's seat, lower lift arms and put attachment on the ground. Engage brake, stop engine, remove key, and remove seat belt.
Check Brush Pattern
A properly adjusted brush offers the best sweeping performance. To check the brush pattern, move the
Figure 4. Brush Pattern
If the brush pattern is not two to four inches wide, adjust brush pattern accordingly.
Figure 5. Adjustment Bolt and Brush Pattern
MAN0661 (8/10/2007) | Operation 11 |
|
|