Zap 815-RL installation instructions Contents

Page 5

CONTENTS
Product Overview	1
Description	2
Fitting the Super-Drive	3
Fitting the Manual Over-Ride lever	5
Fitting the Control unit	7
Fitting the Motor Cover kit	8
Connecting the mains power supply	9
Testing the door operation	11
Door speed change point and limit of travel calibration	12
Safety circuit and Photo-Eye wiring	14/15
Interlock circuit wiring	16
Accessory Radio Receiver wiring	16
Programming	16
Zap Transmitter code programming	17
Auto-Close timer programming	18
Wiring diagrams	19
Fault Finding Guide	22

Image 5

Contents Jackshaft MOTOR-CONTROL System Page Important Installation Instructions Page Contents Manual Over ZAP SUPER-DRIVE MOTOR-CONTROL System For Sectional DoorsJackshaft MOTOR-CONTROL System Fitting the SUPER-DRIVE Operator PreparationPic Pic Fitting the Manual OVER-RIDE Lever MechanismPic Fitting the Control Unit LOW Voltage DC Motor WiringFitting the Motor Cover KIT Do not Plug the Power Plug Into Connecting the Main A/C SupplyPic Push button operation is Press to Open Testing the Door OperationDoor Speed Change Point Calibration Door Direction AssesmentPic Safety Circuit Wiring Volt TWO Wire PHOTO-EYE Wiring Programming Interlock Circuit WiringAccessory Radio Receiver Wiring Transmitter Code Programming Remote Control of the LightZAP 800-R Controller Wiring Accessory Radio Pulse Operation AUTO-CLOSE Timer ProgrammingPage ZAP 800-R Safety Wiring Connections ZAP PHOTO-EYES ZAP 800-R Safety Wiring Connections NON-ZAP Photo Eyes Fault Fault Finding GuideZAP Controls UK