Zap 815-RL Connecting the Main A/C Supply, Do not Plug the Power Plug Into

Page 14

Pic 23

CONNECTING THE MAIN A/C SUPPLY

The Operator should be installed in accordance with local codes and national electric code.

To reduce the risk of electric shock, this equipment has a grounding type plug that has a third (grounding pin). This plug will only fit into a grounding type outlet. If the plug does not fit into the outlet, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.

If it is required to permanently wire the Control unit to the permanent electric wiring in the building then this should be completed by a qualified electrician.

The factory fitted Mains power cord should be secured next. A 1.8 metres / 6 ft main power cable is supplied ready connected to the 800-R controller. It is plugged into the green 3-way connector at the bottom left hand side of the circuit board. (Pic 24)

The power plug can then be located next to a convenient power socket.

Pic 24

DO NOT PLUG THE POWER PLUG INTO THE

SOCKET YET. Please ensure that any unused cable is coiled and secured using cable clips or cable ties provided.

If the Control unit is to be wired permanently into the house wiring circuit, then the main 120 volt (Europe: 220 volt, UK 240 volt) supply lead, with plug attached, should be removed from the Control unit case as follows:

1.Ensure that the main supply plug is disconnected from the line power supply.

2.Unscrew the outer clamp nut of the cable gland through which the main supply cable passes.

3.Unplug the GREEN power connector from the panel socket.

4.Unscrew the three supply wires from the GREEN power connector.

5.Gently pull the cable through the loosened cable gland.

6.Note that two sizes of cable gland entries are provided in the Control unit case, both 3/4” and 7/8”. Either entry may be used to provide a conduit entry point for the new supply wiring. Whichever entry point is not used should be secured with a blanking plug of the correct size.

9

Image 14
Contents Jackshaft MOTOR-CONTROL System Page Important Installation Instructions Page Contents ZAP SUPER-DRIVE MOTOR-CONTROL System For Sectional Doors Manual OverJackshaft MOTOR-CONTROL System Preparation Fitting the SUPER-DRIVE OperatorPic Fitting the Manual OVER-RIDE Lever Mechanism PicPic LOW Voltage DC Motor Wiring Fitting the Control UnitFitting the Motor Cover KIT Connecting the Main A/C Supply Do not Plug the Power Plug IntoPic Testing the Door Operation Push button operation is Press to OpenDoor Direction Assesment Door Speed Change Point CalibrationPic Safety Circuit Wiring Volt TWO Wire PHOTO-EYE Wiring Programming Interlock Circuit WiringAccessory Radio Receiver Wiring Remote Control of the Light Transmitter Code ProgrammingAUTO-CLOSE Timer Programming ZAP 800-R Controller Wiring Accessory Radio Pulse OperationPage ZAP 800-R Safety Wiring Connections ZAP PHOTO-EYES ZAP 800-R Safety Wiring Connections NON-ZAP Photo Eyes Fault Finding Guide FaultZAP Controls UK