Whynter ARC-14SH instruction manual Remote Control, Installing Batteries

Page 15

REMOTE CONTROL

The portable air conditioner can be switched on by the remote control.

NOTE:

Other appliances in the same room controlled by a remote control (TV, radio, stereo, etc.), may cause interferences.

Electronic and fluorescent lamps may interfere with the signal transmissions between the remote control and the air conditioner.

Remove the batteries if the remote control is not used for long periods.

INSTALLING BATTERIES

Only use two AAA 1.5V Batteries in the remote control.

Always change both batteries at the same time.

To insert the batteries, open the flap on the back of the remote control by sliding if off. Strictly adhere to the polarity signs on the bottom of the battery housing, close the flap once the batteries have been inserted.

15 P a g e

Image 15
Contents MODEL# ARC-14SH Table of Contents Disposal Safety Precautions Operating Condition DRYHeat Image Accessory Name Quantity Identification of AccessoriesRear Identification of PartsControl Panel Operating Your AIR ConditionerLocation Installation InstructionsWindow kit Installation AIR Filters Installation Operation Instructions ∙ Before Using Your Portable AIR ConditionerHeat Mode Water Drainage Installing Batteries Remote ControlCleaning the PRE-FILTER Care and MaintenanceARC-14SH Technical DataProblem Possible Causes Solutions TroubleshootingA g e This Warranty does not Cover ONE Year Limited Warranty Three Year Warranty on Compressor