Wayne-Dalton 347610 installation instructions 7000/7400 Series, B l e O f C o n t e n t s

Page 1

7000/7400 Series

T o r s i o n

6” Front Mount Low Headroom

MH

installation instructions and owner’s manual

GARAGE DOORS & OPENERS

T a b l e O f C o n t e n t s

Parts Breakdown

2

Pre-Installation

3

Important Safety Instructions

3

Tools Required

3

Package Contents

3

Door Section Identification

4

Graduated End Hinge And Strut Identification

4

Removing an Existing Door

5

Preparing the Opening

5

Installation

7

Optional Installation

17

Door Arm Hookup

17

Lift Handles

17

Pull Down Rope

17

Maintenance

18

Cleaning Your Garage Door

18

Painting Your Garage Door

18

Clear Or Stained Finishes

18

Operation and Maintenance

18

Warranty

20

Dealer Locator Information

22

IMPORTANT NOTICES!

Wayne-Dalton highly recommends that you read and fully under- stand the Installation Instructions and Owner’s Manual before you attempt this installation.

To avoid possible injury, read the enclosed instructions carefully before installing and operating the garage door. Pay close attention to all warnings and notes. After installation is complete, fasten this manual near garage door for easy reference.

The complete Installation Instructions and Owner’s Manual are available at no charge from:

Wayne-Dalton, a Division Of Overhead Door Corporation, P.O. Box 67, Mt. Hope, OH., 44660,

Or Online At www.Wayne-Dalton.com

©Copyright 2012 Wayne-Dalton, a Division Of Overhead Door Corporation

Part No. 347610

REV1 03/08/2012

Page 1 Page 2
Image 1
Page 1 Page 2
Contents
B l e O f C o n t e n t s 7000/7400 SeriesStacked Sections C1. Top Section Graduated End HingesPackage Contents Important Safety Instructions Tools RequiredGraduated End Hinge Strut Identification Door Section IdentificationPreparing the Opening Removing an Existing DoorRail of the bottom section Headroom RequirementsHeader board 2x Lumber preferred Min. side HeadroomRoom Clearance for Track isPage Strutting Track Roller CarriersRepeat the same process for the right hand side For 2 Long Strut ApplicationsTop Fixtures Half Center HingesVertical Tracks Bottom SectionStacking Sections Horizontal Tracks Adjusting Top FixturesTop Section For Center Hinges and or half center hingesAdjusted for each side Torsion Spring AssemblyEnd Bearing Brackets Center BracketTorsion Spring Attachment For Doors with a Coupler AssemblyTools Step Ladder, 1/2 Wrench If your door came with a Center Bracket BushingTools Vice Clamps Set CollarsRear Back Hangs Winding SpringsSpring Set screws Approved Torsion shaft Winding coneCeiling member Label Placement16-18 x 1-1/4 Parallel to door Door Arm Hookup Tools Power drill, 1/8 Drill bit, Tape measureLift Handles Pull Down RopeOperation and Maintenance Cleaning Your Garage DoorPainting Your Garage Door Clear Or Stained FinishesPage Limited warranty Model 7000 and 7400 Series Warranty
Top Page Image Contents