Wayne-Dalton GSM-12 Transfering Controller Devices to Radio Remote Receiver, Sending

Page 10

Transfering Controller

Devices to Radio Remote

Receiver

1.Connect the communication cable from the GSM-12 to the Remote Radio Receiver.

2.Press the MENU/NO button until the display indicates the Send To Receiver operation.

SEND TO RECEIVER

NO YES

3.Pressing the ON/YES button will display transfer operation activity.

SENDING......

a)When transfer operation is complete, the GSM-12 will display.

SENDING DONE

b)If the communication cable is not connected or the connection is not correct, the GSM-12 will display.

CHECKING COMM.....

c)Then after two seconds the GSM-12 will display.

COMM ERROR

SEND TO RECEIVER

NO YES

SENDING......

SENDING DONE

CHECKING COMM....

COMM ERROR

 

GSM-12

MENU/NO

ON/YES

10

You can reach us Toll Free 1-800-676-7734 for Consumer Assistance

 

or online at www.waynedalton.com

Image 10
Contents Gate System Master Controller Table of contents Definition of Symbol Accessing Battery Compartment Battery InstallationData Cable Connection Genreal Information Protective Cover/StandGSM-12 Press Menu OperationActivating the GSM-12 Learn DEVICE? No YESDuplicate ID-XXX NEW Learn ID-XXXLearn TIME-OUT ID-XXX Yyyyyyy No ERASE? YES Erasing Individual Devices From The GSM-12Erase DEVICE? Noyes ID-XXX Erased No UNDO? YESErasing All Devices From GSM-12 Retrieving Free Storage SpaceSending Transfering Controller Devices to Radio Remote ReceiverSend to Receiver No YES Sending DoneReceiving Transfering Radio Remote Receiver Devices to ControllerGET FRM Receiver No YES Receiving DoneTurning Off GSM-12 Turn Unit OFF? NoyesService Service/Trouble ShootingMaintenance Battery ReplacementFCC and IC Statement FCC and IC StatementLimited Warranty GSM-12