Wayne-Dalton 2411, 2415 warranty Black RED Left Side Illus Trates Single Endcaps Hardware

This illustration shows

15” radius track,

fastened to steel with

TEK Screws

This illustration shows

12” radius track,

fastened to wood with

Lag Screws

This illustration shows

15” radius track,

fastened to concrete

with Concrete Anchors

BLACK

RED

RED

LEFT SIDE ILLUS-

TRATES SINGLE

ENDCAPS AND

HARDWARE

(3) 3/8” x 3/4” truss bolts and nuts.

(2)for securing end bracket

(1)for securing horizontal angle

BLACK

1/4” x 9/16”

track bolt and

nut.

RIGHT SIDE ILLUS-

TRATES DOUBLE

STILES AND HARD-

WARE

Fig. M

STEP 8. Installing the Horizontal Track: Use chain or cable to suspend the rear of the horizontal tracks. Secure the horizontal reinforcing angle to the wall angle using (1) 3/8” x 3/4” truss bolt and nut, then secure the horizontal track to the splice plate or flagangle using (2) track bolts and hex flange nuts.

STEP 9. Installing the Torsion Springs: Torsion spring assemblies can be of several configurations depend- ing on door size and weight. If single spring the left or right hand spring must be identified by the color of the winding cone. (Refer to fig. M and pages 11 & 12)

Slide the cable drums and the end bearing brackets onto the 1 piece shaft (tubular or solid). Slide the cable drums, end bearing brackets and coupler onto each split solid shaft and install similar to 1 piece shaft. Position the shaft to the proper elevation and secure the bearing bracket(s) to the spring pad using the proper fasteners as shown in fig. N-1.

WARNING: DO NOT INSTALL CENTER BEARING BRACKETS DIRECTLY ONTO PANELING OR DRYWALL !

NOTE: Use a chalk line or line level to ensure all bearing brackets are in line. (± 1/8”)

PG. 8