Wayne-Dalton 2415, 2411 warranty Track 1/4 Graduation 9 Sections High or Less

3” TRACK 1/4” GRADUATION 9 SECTIONS HIGH OR LESS

NOTE: 3” TRACK HINGE SCHEDULE ON DOORS LESS THAN OR EQUAL TO 18’-1” HIGH. DOORS OVER 18’-1” HIGH (OVER 9 SECTIONS) WILL REQUIRE 1/8” GRADUATION. BY START- ING WITH (2) #3 HINGES, (2) #4 HINGES, (2) #5 HINGES ETC...

#5 HINGE #4 HINGE

#3 HINGE

FIG.J

Refer to the auxiliary	FIG.F
instructions.

FIG.I

FIG.H

NOTE: DOUBLE END-

STILES BEGIN AT 16’3” WIDE

ON ALL 2411-2415 DOORS

FIG.G

Secure Bracket

using (10) screws.

Align the appropriate end hinge to the pre-punched holes in the stiles and secure using (2) 1/4” x 5/8” self tapping screws per hinge. Products 16’2” wide and less require (1) end hinge (fig. D) and doors over 16’2” wide require double end hinges. (Fig. H)

The end hinge sequence is dependent on track size (2” or 3”).

2” track applications begin with a number 1 hinge attached to the top corners of the bottom section. 3” track applications begin with a number 3 hinge.

( Refer to the illustrations dependant on your track size)

PG. 5