iHome iH 26 manual Using The Remote Control Unit, Install/Replace the Remote Control Battery

Using The Remote Control Unit

Install/Replace the Remote Control Battery

The remote control battery is already installed at the factory. When the remote control stops operating or its range seems reduced, replace the battery with a new one.

1.The battery door is located on the back end of the unit.

2.Pull the battery door to release the battery door latch and take out the battery holder.

3.Insert a “CR2032” 3-volt lithium battery. Make sure the polarity (the + and – side of the battery) is correct.

4.Replace the battery holder back in the remote control.

NOTE: PLEASE DISCARD BATTERIES PROPERLY

Battery door latch

The Remote Control controls basic functions on the iH26 and certain iPod® functions when the iPod® is docked in the iH26. For best results, aim remote control towards the remote sensor on the lower right corner of the unit.

iPod Play/Pause Button	Selects iPod and plays track. In play mode, press to pause
Alarm Reset/	Turns iH26 ON or OFF or reset alarm when alarm is sounding
Power Off Button

Button

Button

Volume+ Button

Volume_ Button

Mute Button

Sleep Button

Snooze/Dimmer Button

Skip to previous or next track when iPod is playing, or HOLD to scan current playing track.

Raises volume level

Lowers volume level

Toggles sound ON or OFF

Selects Sleep Time function

Snooze mode when alarm sounds, otherwise dims display

8