Install Battery
Install/Replace Speaker Batteries
1.Open speaker battery compartment cover located on the bottom of the iH26.
2.Insert 4 "AA" batteries, checking that the polarity ( + and - ends of the batteries) matches the drawing inside the battery compartment. We recommend the use of alkaline batteries for longer life. Different types of batteries or new and used batteries are not to be mixed. Close the compartment cover.
Install/Replace Clock Backup Battery
The iH26 uses a CR2032 button cell backup battery system to provide continuous alarm operation and clock settings in the event of a power failure. If the Backup Battery has been installed and a power failure occurs or the AC cord is accidentally disconnected, the display backlight will not remain lit, but the current time and alarm time settings will be temporarily maintained. Otherwise, you must reset the time and alarm settings.
If the unit has no display or the Backup Battery Low Icon located on the left bottom of the display is flashing, it is time to replace the backup batteries.
1.Please make sure the AC adaptor is connected. Otherwise all settings may be lost during battery replacement.
2.Open backup battery compartment cover located on the bottom of the unit.
3.Insert one CR2032 button cell battery, checking that the polarity ( + and - ends of the batteries) matches the drawing near the battery compartment. Close the compartment cover.
Batteries information:
•Do not mix old and new batteries.
•Do not mix alkaline, standard
•Make sure you dispose of batteries properly (see your local regulations).
Maintenance
Place the unit on a level surface away from sources of direct sunlight or excessive heat.
Battery install for
Clock display back up
Protect your furniture when placing your unit on a natural wood and lacquered finish. A cloth or other protective material should be placed between it and the furniture.
Clean your unit with a soft cloth moistened only with mild soap and water. Stronger cleaning agents, such as Benzine, thinner or similar materials can damage the surface of the unit.
5