Operating Instructions Instructions d’Utilisation Manual de Instrucciones
Notes
Notas
1/2 HP Cast Iron
Sewage Pump
Please read and save these instructions. Read carefully before attempting to assemble, install, operate or maintain the product described. Protect yourself and others by observing all safety information. Failure to comply with instructions could result in personal injury and/or property damage! Retain instructions for future reference.
Operating Instructions | Model RPP50 |
|
|
Description
This sewage pump is suitable for pumping sewage, effluent, wastewater, groundwater and other nonexplosive, noncorrosive liquids with up to two inch solids. The pump includes a wide angle float switch that turns the pump on and off as the fluid level rises and falls.
Unpacking
Inspect this unit before it is used. Occasionally, products are damaged during shipment. If the pump or components are damaged, return the unit to the place of purchase for replacement. Failure to do so could result in serious injury or death.
Safety Guidelines
This manual contains information that is very important to know and understand. This information is provided for SAFETY and to PREVENT EQUIPMENT PROBLEMS. To help recognize this information, observe the following symbols.
Danger indicates
! DANGER an imminently hazardous situation which, if not avoided, will result in death or serious injury.
Warning indicates
! WARNING a potentially hazardous situation which, if not avoided, could result in death or serious injury.
Caution indicates a
! CAUTION potentially hazardous situation which, if not avoided, MAY result in minor or moderate injury.
NOTICE Notice indicates important
information, that if not followed, may cause damage to equipment.
General Safety
Information
1.Know the pump application, limitations, and potential hazards.
!WARNING
Do not use to pump flammable or explosive fluids such as gasoline, fuel oil, kerosene, etc. Do not
use in flammable and/or explosive atmospheres. Use pump only with liquids compatible with pump component materials. Failure to follow this warning can result in personal injury and/or property damage.
2.Make certain that the power source (electric motor) conforms to the requirements of the equipment.
! DANGER
Disconnect power before servicing. If the power dis- connect is out of sight, lock in the open position and tag it to prevent unexpected application of power. Failure to do so could result in fatal electrical shock!
Specifications
Power supply requirements | ......120V, 60 hz |
Circuit requirements | 15 amps (min) |
Motor duty | Intermittent |
Motor | 120V, 1 Phase |
Horsepower | 1/2 |
Motor full load | 6.3 amps |
Liquid temperature range | 40°F to 120°F |
Max. operating position | 45o from vertical |
Dimensions | 14” x 12” |
Intake | 2” |
Discharge | 2” NPT female |
16” | |
7.5” | |
Differential | 8.5” |
Switch | 90o wide angle |
| mechanical tether switch |
Power cord | 18 gauge 3 conductor |
| w/plug |
Construction
Motor housing | ...........................Cast iron |
Volute | Cast iron |
Impeller | Glass reinforced PBT |
Seal plate | Cast Iron |
Shaft seal | Mechanical |
Performance
| GALLONS PER HOUR AT TOTAL HEAD IN FEET |
| ||
Model | 0 | 5 | 10 | 15 |
RPP50 | 5700 | 4560 | 3240 | 900 |
REMINDER: Keep your dated proof of purchase for warranty purposes! Attach it to this manual or file it for safekeeping.
© 2004 Wayne Water Systems | For parts, product & service information |
visit www.waynepumps.com