Before you start !
The Style RX unit voltage must correspond with your mains voltage. Style RX are delivered in 120V or 230V versions.
Before connecting for the first time, check to make sure that your Modelling lamp coincides with the voltage line.
They must always be connected to an earthed ( grounded) mains supply.
All Style RX units have a bayonet mount and locking ring reflector fitting, for fixing all Elinchrom and Prolinca accessories.
Mount the unit securely to a suitable stand or support.
Remove the black protective cover (note: first turn the locking ring A as shown, then rotate the black cap cover B in the same direction).
Fitting a reflector or accessory is the reverse of this action. | handle |
| A |
| locking |
| B |
| protective |
| cover |
Operating instructions
1.Check that the modelling lamp voltage is correct.
2.Check that the mains switch (3) is in the OFF ("O" position).
3.Insert mains cable to the MAINS INLET (1) and connect to a FULLY EARTHED OUTLET 4.Using the mains SWITCH (3) and switch the unit ON ("I" position).
5.Connect the synchro cord on the socket (6). 6.Select the power with the touch pad (11 - 12)
12
11
6
1
3
5