Kidde C3010-D manual Model C3010 Operating Characteristics, Operating and Alarm Characteristics

5. Model C3010 Operating Characteristics

Whenever the alarm is operating, the green Power LED flashes every 30 seconds to indicate the unit is monitoring for CO. If the alarm senses dangerous levels of CO, the red Alarm LED will flash and the alarm will emit an audible alarm pattern.

Operating and Alarm Characteristics

Function	LED Display	Alarm Sound	Unit Status	Recommendation
Normal	Green LED	None	Normal	None
Operation	flashes every 30		operation
	seconds
		4 quick beeps, 5		Refer to “What to do
Carbon	Red LED flashes	seconds silence -	Alarm condition.
monoxide		continuous for first	Dangerous concentra-	When the Alarm Sounds”
	with beeps.	4 minutes then 2		(inside front cover)
alarm			tions of CO detected
		patterns once a
		minute there after
			Unit batteries are not	If unit is cold, allow to warm
	Amber LED flashes	quick beep		up above 68°F. If the unit is
Low			capable of powering
				at room temperature and is
	every second	every	the unit either because
battery				beeping /flashing every 60
		60 seconds	of age, storage or the
				seconds the unit needs to be
			voltage of the battery
				replaced.
	Amber LED flashes			Press and hold the test
Error /	every second green	quick beep every	Unit is in error	button for 5 seconds to
	LED blinks error			perform a reset. If unit
Service alarm		30 seconds	condition
	code every other			continues to beep or
	30 seconds.			alarm, using a screwdriver
		Constant	Very low battery or	slide the switch on the
Error				back of the unit up to the
		Tone	unit malfunction	shut down position. Unit
				will not respond to CO.
Normal	Red LED flashes	4 quick beeps, 5	Normal operation
		seconds silence		CO not detected. Alarm
Test/Reset	and Green LED
		– repeated once	when Test/Reset
	on. Amber on at			for test purposes only
function		(1st at reduced	button is pressed
	button press and
		level,2nd at full
	temporal pattern
		volume )

Event	Red LED	None	High level of CO
memory	flashes every 60		detected within the
	seconds.		last 14 days

Perform a test/rest on the unit and monitor for repeat occurrences

End of unit life indicator

Amber LED flashes every second and green LED blinks error code every other 30 seconds.

Sequence of two	End of unit life	Replace unit immediately. Using
beeps every 30		a screwdriver slide the switch on
seconds		the back of the unit up to the
		shut down position. Unit will not
		respond to CO.

6.Model C3010-D (with digital display) Operating Characteristics

When the unit is first powered up, the green Operate LED flashes once every 30 seconds and the digital display will show three “eights” – indicating the alarm is in the start-up mode. The three “eights” will remain for approximately 30 seconds. Then, the alarm will display “0” and begin monitoring the air for CO and will continue to do so as long as it receives power.

This alarm will display a “0” if CO concentrations between 0 and 30 PPM have been detected within the last 15 seconds.