4. Installation Instructions
Mounting
This CO alarm can be either wall mounted or placed on a tabletop.
For wall mounting, follow these steps:
1. Using the mounting bracket, place it in the desired location and mark the loca- tion of the two holes needed on the wall.
2. Insert the two screws provided until the | Screw Head Distance | |
screw heads are protruding approxi- | ||
from Wall | ||
mately 1/8” from the wall. (If mounting |
| |
in a plasterboard or drywall, drill |
| |
a 3/16” hole in the wall and use |
| |
the plastic anchors provided.) |
| |
3. Hook the CO alarm over the |
| |
screws and onto the keyholes in |
| |
the back mounting plate of the |
| |
alarm. After the mounting plate |
| |
is secured to the wall, slide the |
| |
alarm down over the mounting |
| |
plate until it snaps into place. | Wall Mount |
The alarm is now activated!
Your CO alarm may also be placed on a tabletop. If alarm is not wall mounted, then be sure the alarm is no more than three feet from the floor to minimize the risk of causing permanent damage to the alarm in the event that it is knocked to the ground by accident.
The alarm is activated once the mounting bracket/back cover is installed! Once activated, removing the mounting bracket/back cover will not turn it off. The unit will remain on for the next ten years.
Important Labels Provided
A label has been provided that has important information on what to do in case of an alarm. Add the phone number of the emergency service provider in the space provided. Place the label near to the alarm where it can be seen in an emergency situation.