Honeywell M9494, M9491, M9481 manual Location, UIMtNSIUNS

Page 4

f--- 5.37 [136]

ADAPTER

BRACKET

FIG. 1-UIMtNSIUNS IN In.

NOTE: M9481, M9491 do not have auxiliary shaft. All other dimensions are the same.

LOCATION

install the Modutrol motor in any location except where acid fumes or other deteriorating vapors might attack the metal parts, or in atmospheres of escaping gas or the explosive vaporsin excessive salt environments, mount- ing base and screws should be zincorcadmium plated, not stainless steel or brass: Use the 220738A adapter bracket for mounting on these surfaces.

Allow enough clearance for installing accessories and servicing the motor when selecting a location. See Fig. 1. If located outdoors, mount upright and use liquid-tight con-

duit connectors with wiring box to provide NEMA 3 weather protection.

MOUNTtNG

Always install motors with the crankshaft horizontal. Mounting flanges extending from the bottom of the

motor housing are drilled for l/4 inch [6.4mm] machine screws or bolts.

Motors are shipped from the factory in closed position (at the limit of counterclockwise rotation as viewed from the power end of the motor, as shown in Fig. 2) with the stroke set at 90”.

4

Page 3 Page 5
Image 4
Page 3 Page 5
Contents Honeywell Power Rating Electrical Ratings Voltage Power Current Consump Draw aDead Weight Load on Shaft Control Type T TTLix LetterAccessories When Installing this ProductUnderwriters Laboratories INC. Listed Canadian Standards Association CertifiedLocation UIMtNSIUNSDamper Linkages Which thread into the threaded bracket holesWiring Disconnect power supply before wiring to prevent electriWiring BOX Valve LinkagesLNTERNAL Wiring of An9494 Modutrol 63-2195-lCAM LOCATIONa963-2195-l Move Screwdriver AT TOPSetting 90 Stroke Fig Auxiliary SwitchesAuxiuary SWlTCH SElllNG Procedure Fig Connection Diagrams FigsOptional Connections A Douglas Drive N
Top Page Image Contents