2 Maintenance schedule
Maintenance procedures
Boiler must be serviced and maintained
User’s Information Manual
Read the list of potential materials listed in Table 1A on page 4 of this manual. If any of these products are in the room from which the boiler takes its combustion air, they must be removed immediately or the boiler combustion air (and vent termination) must be relocated to another
WARNING
NOTICE
The boiler must be inspected and started annually at the beginning of the heating season by a qualified service technician. In addition, the maintenance and care of the boiler designated on page 5 of this manual and explained on pages 6 through 8 must be performed to assure maximum boiler efficiency and reliability. Failure to service and maintain the boiler and system could result in equipment failure, causing possible severe personal injury, death, or substantial property damage.
The following information provides detailed instructions for completing the maintenance items listed in the maintenance schedule on page 5. In addition to this maintenance, the boiler must be serviced and started up at the beginning of each heating season by a qualified service technician.
area.
Check pressure/temperature gauge
1.Make sure the pressure reading on the boiler pressure/ temperature gauge does not exceed 24 psi. Higher pressure may indicate a problem with the expansion tank.
2.Contact a qualified service technician if problem persists.
Check vent piping
1.Visually inspect the flue gas vent piping for any signs of blockage, leakage, or deterioration of the piping. Notify your qualified service technician at once if you find any problems.
WARNING Failure to inspect the vent system as noted above and have it repaired by a qualified
service technician can result in vent system failure, causing severe personal injury or
Check boiler area
death.
WARNING
To prevent potential of severe personal injury, death, or substantial property damage, eliminate all materials discussed below from the boiler vicinity and the vicinity of the boiler combustion air inlet. If contaminants are found:
Remove products immediately from the area. If they have been there for an extended period, call a qualified service technician to inspect the boiler for possible damage from acid corrosion.
If products cannot be removed, immediately call a qualified service technician to
Check air piping
1.Visually inspect the air inlet termination to be sure it is unobstructed. Inspect the entire length of air piping to ensure piping is intact and all joints are properly sealed.
2.Call your qualified service technician if you notice any problems.
Check relief valve
1.Inspect the boiler relief valve and the relief valve discharge pipe for signs of weeping or leakage.
2.If the relief valve often weeps, the expansion tank may not be working properly. Immediately contact your qualified service technician to inspect the boiler and system.
Check condensate drain system
1.Combustible/flammable materials
2.Air contaminants
6
Inspect/check condensate lines and fittings
1.Inspect the condensate drain line, condensate fittings and condensate trap.
2.Fill condensate trap with enough water to make the ball float (FIG.
3.Loosen compression fitting (FIG.
4.Slide condensate trap onto condensate drain at the bottom of the unit.
5.Tighten compression fitting.