Lochinvar WH 55 - 399 manual Smart System control module, User, Installer, Time and date

Page 11

User’s Information Manual

4 SMART SYSTEM control module

Knight wall mount control module

Use the control panel (FIG. 4-1) to set temperatures, operating conditions, and monitor boiler operation.

Figure 4-1Control Panel

NAVIGATION DIAL

The information on the bottom of the display shows the functions of the two SELECT keys (on either corner), and the NAVIGATION dial (in the center): MENU = Left SELECT Key

SETPOINTS = NAVIGATION Dial - Pressing Down SHDN = Right SELECT Key

Access modes

NOTICE Please note that the brackets ([]) denote screen status.

User

The user can adjust space heating and tank target temperatures by pressing the NAVIGATION dial when “SETPOINTS” is flashing at the bottom of the display. The user can adjust the date and time, night setback override,temperature units, and night setback override (if active) by pressing the LEFT SELECT [MENU] key for 5 seconds. When the user password “0000” appears, then press the RIGHT SELECT [SAVE] key (do not change the password).

Installer

Most parameters are available only to the installer, accessible only by entering the installer password, see the Knight Boiler Service Manual.

Saving parameters

Press the RIGHT SELECT [SAVE] key one time to return to the parameter listing. Press the RIGHT SELECT [HOME] key again to store the new settings and return to the Status Screen.

Adjusting parameters

CAUTION

Before changing parameters, note the

settings so that the unit can be returned to

 

 

its original operating parameters.

Time and date

 

The control uses an internal clock for the night setback feature and for logging of events. For these features to work properly, the clock must be set when the boiler is first installed or any time the boiler has been powered off for more than four (4) hours. This parameter must be accessed to set the clock.

NOTICE

The internal clock does not adjust for

Daylight Savings Time and therefore, will

 

require a manual adjustment.

To set the clock, access the clock menu as described in the

User section. Rotate the NAVIGATION dial (if needed) until

the arrow (>) is pointing to “TIME & DATE”. Press the

NAVIGATION dial once. If the date and time are incorrect,

press the NAVIGATION dial again. The hours value will

begin flashing. Rotate the NAVIGATION dial until the hour

and AM/PM values are correct. Press the NAVIGATION

dial again. The minutes value will begin flashing. Rotate

the NAVIGATION dial to adjust the minutes. Repeat this

procedure to adjust the month, date and year. Save the new

settings as described in the Saving Parameters section (this

page).

11

 

Image 11
Contents User’s Information Manual Models WH 55 Contents Please read before proceeding Boiler service and maintenanceAreas likely to have contaminants Prevent combustion air contaminationProducts to avoid See pages 6 8 for detailed instructions Maintenance schedule Service technicianOwner maintenance Inspect/check condensate lines and fittings Maintenance scheduleCondensate disposal Clean/Inspect Trap AssemblyTest low water cutoff if installed 1Operating Instructions Models 55 Operating instructionsOperating instructions Time and date InstallerSmart System control module UserSpace heating SH1, SH2, SH3 and tank set points Temperature UnitsNight Setback Override Call for Heat Information Right Select no