Jotul GF 3 BV manual Remove the regulator tower and the gasket

Page 11

8.Adjust the air shutter on the burner tube to allow for the proper mixing of air and gas. See Figure 2. The correct settings: natural 1/4” open

propane 1/4” open

Figure 2

AIR SHUTTER

 

 

 

 

BURNER TUBE

 

 

 

 

ATTENTION: Air shutter should never be LESS than 1/8” open.

WHENRE-INSTALLINGTHEBURNERTUBEBESURE THAT THE TUBE IS PULLED FORWARD IN THE MOUNTING HOLES, SECURE WITH THE TWO 1/4” SCREWS.

9.Change the pilot orifice. FROM WITHIN THE FIREBOX, PULL THE PILOT HOOD OFF THE PILOT ASSEMBLY. Using a 4mm allen wrench thread out the pilot orifice (counter clockwise). Replace with the appropriate orifice: See Figure 3.

#51or natural gas #30 for propane

Tighten orifice into the base of the pilot assembly. Be sure the orifice is threaded tightly and flush with the base.

10.Replace pilot hood onto pilot assembly.

PILOT HOOD

PILOT

ORIFICE

PILOT ORIFICE

SCREWS INTO

BASE

Figure 3.

11.Change the variable regulator on the valve (Hi/ Lo knob). Using a Torx t-20 screwdriver, remove the three specialty screws from the front of the valve regulator. See Figure 4.

12.Remove the regulator tower and the gasket.

BE SURE TO REMOVE THE BLACK RUBBER GASKETS FROM THE VALVE!!!

See Figure 4.

13.Install the new variable regulator tower with the new rubber gasket.

Thoroughly tighten new regulator to valve body.

BESURETOREMOVE

THE BLACK RUBBER

GASKET FROM THE

VALVE!!!

Figure 4.

14.Install the identification labels to the stove so that they can be seen by any person that may be servicing the stove.

15.Reassemble the stove, apply gas to the system and check for gas leaks including all stove lines before and after the valve.

NEVER USE AN OPEN FLAME TO CHECK FOR GAS LEAKS.

ATTENTION!! ATTENTION!!

This is very important

Correct gas pressure is essential for efficient and safe operation of the Allagash B-Vent gas stove. It is important that the correct gas pressure be established at the time of the installation. For more details, see the Gas Pressure section of this manual on page 13.

ALWAYS REFER TO THE LIGHTING INSTRUCTIONS ON PAGE 23 OF THIS MANUAL WHEN LIGHTING YOUR ALLAGASH.

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Warnock Hersey GF 3 BV AllagashModel Allagash B-Vent Gas Stove Table of ContentsInput Rates Welcome to JøtulDo not Operate this Stove if ANY Part has Been Under Water StandardsLocation Hot SurfacesBlower/Electrical Hazard Corner clearance =376mm Floor ProtectionStove Clearances Rear clearance =250mmVenting Requirements Firestop is required at every floor Venting Configurations for Included in the conversion kit GAS ConversionTools required Remove the regulator tower and the gasket GAS Pressure Making the GAS ConnectionNecessary Manifold Pressures High Altitude InstallationsNecessary Inlet GAS Pressures Inches water columnGAS Type Orifice Elevation Jøtul Size AIR Shutter ADJUSTMENT/FLAME AppearanceInstalling the LOG SET Reminder Installing the Optional BlowerSpill Switch Installing the Optional Wall Thermostat or RemoteChecking the System Operation of Appliance MaintenanceService LOG Allagash B-VENT Parts List GF3 BV Allagash Illustrated Parts Breakdown Lighting Instructions Jøtul ASA

GF 3 BV specifications

The Jotul GF 3 BV is a gas-burning fireplace that combines classic design with modern technology, making it a popular choice for homeowners seeking both style and efficiency. This model is part of the renowned Jotul family, known for their high-quality craftsmanship and lasting durability.

One of the standout features of the Jotul GF 3 BV is its impressive heat output. With an efficiency rating that rivals many wood-burning stoves, this gas fireplace can easily warm up larger spaces, making it ideal for living rooms, family areas, or open floor plans. The unit delivers a maximum input of 20,000 BTUs, allowing it to provide substantial warmth without the hassle of traditional wood fires.

The design of the Jotul GF 3 BV reflects a timeless aesthetic that can suit various interior styles. It features a beautiful cast iron construction, which not only contributes to its durability but also adds a classic touch to the ambiance of any room. The unit is available in multiple finishes, including natural gas and propane, allowing homeowners to choose the best option that fits their existing decor and preferences.

In terms of technology, the Jotul GF 3 BV includes an innovative venting system that allows for flexible installation options. This system is designed to minimize the need for extensive chimney work, making the unit easier to install in various settings. Additionally, the fireplace is equipped with a ceramic glass window that provides an unobstructed view of the flames while maintaining the efficiency of the fire.

Another significant characteristic of the Jotul GF 3 BV is its intuitive control system. This allows users to easily adjust the flame height and heat output, providing customizable comfort levels at the touch of a button. The fireplace can also be integrated with remote control options for added convenience, showing Jotul's commitment to modernizing traditional fireplace experiences.

Overall, the Jotul GF 3 BV is an excellent choice for those looking for an efficient, stylish, and easy-to-use gas fireplace. With its combination of classic design, high efficiency, and user-friendly features, it represents a perfect blend of form and function for contemporary living spaces. Whether you are renovating your home or simply seeking an efficient heating solution, the Jotul GF 3 BV delivers on all fronts.
Top Page Image Contents