VENT-FREE PROPANE/LP GAS STOVE HEATER
INSTALLATION
Continued
STOVE CAVITY ASSEMBLY
1.Lift off corrugated box enclosing stove body crating.
2.Remove all screws fastening the wood frame enclosure. Spread wood frame open and lift away from
3.Remove plastic bag from stove body.
4.Remove back panel from stove (see Figure 5). Use an adjustable wrench or a 10 mm socket. Remove six (6) bolts and washers. Keep bolts and washers to reattach back panel later.
5.Remove all contents from inside stove cavity. Contents include:
(1) - Stove bottom
(4)- Legs (Amity models include leg leveler bolts)
(1)- Bottom door
(1)- Top grate
(1)- Hardware kit bag with fasteners
6.Carefully lay stove body on back to attach bottom components to stove body (see Figure 6). Rest stove on drop cloth or blanket to avoid scratching stove edges.
7.Remove remaining pallet wood at- tached to bottom of stove body (see Figure 7). Use an adjustable wrench to remove bolts.
8.Fasten each leg to stove with four (4) bolts. Use a flat screw driver to tighten bolt to leg. Thread bolt in tapped holes on stove body (see Figure 8 and Figure 9, page 9).
Bolt
Product |
| Back Stove Panel |
| |
Identification Label |
| |||
|
|
| ||
Figure 5 - Removing Back Panel |
|
| ||
| Top of Stove Unit |
|
| |
|
|
| Front of |
|
|
|
| Stove Unit | Top of |
Front of |
|
|
| Stove |
Stove Unit |
|
|
| Unit |
|
|
| Pallet Wood |
|
Drop Cloth/ |
|
| Bolted to |
|
Blanket |
|
| Stove Body |
|
|
|
| Bottom |
|
Figure 6 - Laying Down Stove On Side (Stove Style May Vary Depending on Model)
Front
Bolt | Pallet | |
Wood | ||
|
Bottom Of
Stove Unit
Pallet
Wood
Figure 7 - Removing Pallet Wood From The Bottom of The Stove
Door Hinge Step |
| Door Catch Bolt |
Bolt Hole | Front | With Adjustable |
| Hex Nuts Hole | |
|
| |
Leg |
| Leg |
Hole |
| Hole |
Bottom Of
StoveStove Unit
Bottom
Holes
Leg | Leg |
Hole | Hole |
Figure 8 - Locating Threaded Holes for Stove Bottom, Legs, and Door Attachment (Appearance May Vary Depending on Model)
8 | 104464 |