Desa RCP25 owner manual Installation Ventilation Operation, To Start Heater

Page 7

INSTALLATION

Continued

VENTILATION

OPERATION

4.Open propane supply valve on propane tank(s) slowly. Note: If not opened slowly, excess-flow check valve on propane tank will stop gas flow. If this happens, close propane supply valve and open again slowly.

5.Check all connections for leaks.

WARNING

Never use an open flame to check for a leak. Apply a mix- ture of liquid soap and water to all joints. Bubbles forming show a leak. Correct all leaks at once.

6. Close propane supply valve.

WARNING

Provide at least a 0.14 m2 (1.5-square-foot) opening of fresh, outside air while running heater. If proper fresh, outside air ventilation is not provided, carbon monoxide poisoning can occur. Provide proper fresh, outside air ventilation before running heater.

IMPORTANT: Provide extra fresh air if more heaters are being used.

WARNING

Review and understand the warnings in the Safety Informa- tion section, pages 2 and 3. They are needed to safely operate this heater. Follow all local codes when using this heater.

To Start Heater

1.Follow all installation, ventilation, and safety information.

2.Locate heater on stable and level surface. Make sure strong drafts do not blow into front or rear of heater.

3.Plug power cord of heater into a three-prong, grounded extension cord. Extension cord must be at least two meters (six feet) long, CSA listed, and of a proper size.

Extension Cord Wire Size Requirements

Up to 15 meters (50 feet) long, use 18 AWG rated cord.

15.5 to 30.5 meters (51 to 100 feet) long, use 16 AWG rated cord.

31 to 61 meters (101 to 200 feet) long, use 14 AWG rated cord.

4.Plug extension cord into a 120 volt/60 hertz, 3-hole, grounded outlet. Depress start switch for three seconds to start motor and fan. This will force air out front of heater.

Continued

7

101489

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Canadian Propane Construction Heater Contents Safety Information Safety Information Product Identification UnpackingSupply TheoryOperation PropaneRegulator Position InstallationTo Start Heater Installation Ventilation OperationTo Restart Heater To Stop HeaterDisconnect heater from propane supply tanks Storage MaintenanceTROUBLE- Shooting Observed Fault Possible Cause RemedyMotor Service ProceduresMotor FanIgnitor Causing severe burnsSpecifications Parts Not Under Warranty AccessoriesTechnical Service Service Publications Replacement Parts Parts Under Warranty101489 101489 Limited Warranty Warranty and Repair ServiceAppareils Dos du manuel Table DES MatièresAvertissements Suite Nomenclature DES PIÈ CES DÉ BallageNctionnement Principes DEEN Propane Avertissement Mise en marche de l’appareil Ventilation FonctionnementPour remettre l’appareil en marche Pour arrê ter l’appareil de chauffageDé brancher l’appareil du ou des ré servoirs de propane Remisage EntretienAnomalie Observé E Cause Probable Remè DE DÉ PannageAnomalie Observé E Cause Probable Moteur Procé Dure D’ENTRETIENDé pose ou fixation du ventilateur sur l’arbre du moteur Moteur suiteAllumeur VentilateurRetrait de la vis de montage et de l’allumeur Allumeur suiteSPÉ Cifications Piè ces qui ne sont pas sous garantie AccessoiresService Technique Publications Techniques Piè ces sous garantieGarantie Limité E Garantie ET Service DE RÉ Paration
Top Page Image Contents