Grizzly G0691, G0690 owner manual Extension wings installed

5.Insert the lip of the lower part of the dust port into the cabinet and tighten the thumb knob (already installed) to secure (see Figure 15).

Thumb Knob

Figure 15. Dust port installed.

6.Remove the M8-1.25 x 30 cap screws, and 8mm flat washers and lock washers from the ends of the main table.

7.Inspect the extension wings and main table mating surfaces for burrs or foreign materials that may inhibit assembly.

The mating edges of the wings and the table must be clean, smooth, and flat. Use a wire brush or file if necessary to clean up the edges. This step will ensure that the wings mount properly to the main table.

8.While a helper holds the wings in place, attach each extension wing to the main table with the four M8-1.25 x 30 cap screws, 8mm lock washers and 8mm flat washers removed in Step 6 (Figure 16).

9.Place the straightedge across the extension wings and main table to make sure that the combined table surface is flat.

—If the combined table surface is flat, skip to the next step.

—If the outside end of the extension wing tilts down, use a strip of masking tape along the bottom edge of the main table to shim the extension wing up (Figure 17).

Figure 17. Masking tape location for tilting the

extension wing up.

—If the outside end of the extension wing tilts up, use a strip of masking tape along the top edge of the main table to shim the extension wing down (Figure 18).

Note: After reinstalling wings, remove all excess masking tape with a razor blade.

x4

Figure 16. Extension wings installed.

-24-

Figure 18. Masking tape location for adjusting

the extension wing down.

Model G0690/G0691 (Mfg. 11/10+)