Grizzly owner manual G0690 Extension Table, G0691 Extension Table

Note: Before tightening the fasteners, check to make sure the top edge of the rear rail is flush with the lowest edge of both T-slots (see Figure 23), so the miter gauge will slide smoothly when installed later.

Figure 23. Verifying rear rail is flush with bottom

of T-slot.

G0690 Extension Table

1.Install the extension table between the front and rear rails with the four M8-1.25 x 30 hex bolts, eight 8mm flat washers, four 8mm lock washers, and four M8-1.25 hex nuts, as shown in Figure 24.

Figure 25. Adjusting Model G0690 extension table flush with extension wing and table.

G0691 Extension Table

1.Remove the six M8-1.25 x 30 hex bolts, (12) 8mm flat washers, six 8mm lock washers, and six M8-1.25 hex nuts from the extension table.

2.While an assistant holds the extension table between the front and rear rails, fasten the extension table to the rails with the fasteners removed in Step 1.

3.Thread the feet into the legs with the two M8-1.25 x 60 hex bolts, place the legs under the table, and thread the feet out until the top of each leg is against the underside corner of the table.

4.Use the four M8-1.25 x 20 cap screws, 8mm lock washers, flat washers, and M8-1.25 hex nuts to secure the legs to the end of the extension table, as shown in Figure 26.

Figure 24. Model G0690 extension table

installed.

2.Using a long straightedge, adjust the exten- sion table so it is flat (both flush and paral- lel) with the main table and extension wings (Figure 25), then tighten the fasteners.

-26-

x4

Foot

Figure 26. Model G0691 extension table

installed.

Model G0690/G0691 (Mfg. 11/10+)