Niles Audio SS-6 specifications Operation, Installation, Tuner

S P E A K E R S E L E C T I O N S Y S T E M

Operation

There are two ways to use the SS-4/SS-6. You may play one pair of speakers at a time, or play multiple pairs simultaneously.

If you intend to play more than one pair of speakers at the same time, you will need to become familiar with the opera- tion of the SS-4/SS-6’s Protection button.

Receiver

TUNER 94.9	Figure 2
15	Wiring Diagram

		Niles SS-4
Niles Audio Corporation Miami, Florida USA
AMPLIFIER	SPEAKER 4	SPEAKER 3	SPEAKER 2	SPEAKER 1

	Speaker	Speaker	Speaker	Speaker
9	Pair 4	Pair 3	Pair 2	Pair 1

S P E A K E R S E L E C T I O N S Y S T E M

Installation

1.Select a convenient mounting location for the SS-4/SS-6.

2.Run all the necessary wiring to the SS-4/SS-6. Label the wires for future reference. See (Figure 2).

3.Locate the connector plugs (and remove them if they are plugged in). See (Figure 2).

4.Strip 1/4" of insulation from the end of each wire. Tightly twist the end of each wire until no frayed ends remain.

5.Use a small flathead screwdriver or your thumbnail to raise the locking tabs, exposing the holes on the removable con- nector plug.

6.Insert each wire into the appropriate hole on the removable connector plug, and snap the locking tab down.

NOTE: To help you avoid improper installation, the connector plug is keyed.

7.Insert the smooth side of the connector plug into the smooth side of the socket. Don’t force the scalloped side of the connector plug into the smooth side of the socket. See (Figure 3).

The inputs of the SS-4/SS-6 are the connector terminals labeled “AMPLIFIER”. The outputs are the connector termi- nals labeled “SPEAKERS”. Be sure not to reverse these con- nections or the SS-4/SS-6 will not function properly.

8.Locate the pre-printed Room Labels. Affix the appropriate label to the recessed area over each on/off selector button.

6