Programming Custom User Codes
In addition to the preset authority levels, you can also create custom authority levels by selecting the CUSTOM option at the time the user is being added to the system. This option allows you to assign specific User Menu access to individual users.
Adding User Codes
1.Access the User Menu.
2.Press COMMAND until USER CODES? displays. (NOTE: You must have a level 9 authority. If you enter the User Menu with a lower authority, the keyboard will not display USER CODES?.)
3.Press any SELECT key. ADD DEL CHG displays.
4.Press the SELECT key under ADD to add a new user code.
5.At the USER NUMBER:- prompt, enter a user number and press
COMMAND. The display changes to CODE
6.Enter a user code of 3 to 5 digits and press COMMAND. The user enters this number each time they make changes. If using access cards, present the card instead of entering a code. The code is displayed for four seconds. After the code is entered, the display changes to USER NUMBER ###.
7.A 16 character name may be entered to identify the user. Press any top row key to clear the current name. You may then enter the new name. After the name is entered, press COMMAND.
8. The display changes to LEVEL CUSTOM. Select LEVEL to assign a standard set of authorized functions as outlined in the User Code Authority Levels table on the previous page.
9.At the LEVEL: - display, enter an authority level from 1 to 9. Press COMMAND. The displays shows USER # ADDED.
10.Select CUSTOM to customize the functions you want the user to access. This allows users to have certain capabilities outside of a standard authority level. The following chart shows the custom menu with default selections.
ALM SLNC (alarm silence) | NO | USR CODE (user code) | NO |
SNSR RST (sensor reset) | NO | TIME (day, date, and time) | NO |
OUTPUTS (outputs on/off) | NO | DIS EVNT (display events) | NO |
ZN STATS (zone status) | NO | TEMP CODE (temporary code)* | NO |
SYS STAT (system status) | NO | SERV REQ (service request) | NO |
SYS TEST (system test) | NO | FIRE DRIL (fire drill) | NO |
*YES allows you to then enter the number of days (1 to 250) that a temporary user code can operate. Default is 7 days. Temp users are deleted from the system at 12:00 AM on the last day.
11.Press the ARROW key to exit the User Menu.
Note: It is recommended that user codes be enabled for only the function shown above. Other burglary functions are available to add to a user code, but are not relevant and, therefore, are not recommended.
10 | User Menu |