Ei Electronics Ei220EN manual Read this First

Page 3

B15584-R0-225EN&220EN-U&C 6/9/07 8:13 AM Page 3

1. READ THIS FIRST

WARNING: The Ei225EN Alarm should be permanently wired to the mains by a qualified electrician in accordance with IEE wiring regulations (BS7671).

?

?

The Ei220EN is just plugged in to the mains.

Install the Carbon Monoxide Alarm (CO Alarm) in every room that contains a fuel burning appliance, particularly rooms where people spend a lot of time e.g. bedrooms, kitchens and sitting rooms.

In rooms with an appliance install (preferably) on the ceiling, (300mm from walls), and between 1m to 3m horizontally from appliance. In rooms remote from the appliance install at breath level, where the light indicators can be seen.

Regularly check that the green power light is on. Important: The CO Alarm will not work if the mains supply is off.

Test the unit weekly by pressing the test/hush button-the horn will sound.

Open the unit by sliding the cover up as shown in figure 1. Then remove the terminal block screw. (Ei225EN only).

Immediately the unit is powered the green light will turn on & the red & amber lights will flash once to show they are operational.

Replace unit after up to 6 years operation (see ‘Replace by’ date on sidewall label).

3

Image 3
Contents Instructions Contents Read this First What to do When the Alarm Sounds Carbon Monoxide the Silent Killer What is Carbon Monoxide ?High levels of CO in a house can be caused by Symptoms of Carbon Monoxide PoisoningB15584-R0-225EN&220EN-U&C 6/9/07 813 AM Table a Effects of Carbon Monoxide Poisoning What happens when your CO Alarm detects Carbon Monoxide ?Never Ignore the Alarm CO Alarm Memory Unsuitable Locations Where to Place CO AlarmsB15584-R0-225EN&220EN-U&C 6/9/07 813 AM Location in room with a fuel burning appliance Location in rooms with Installing Your Carbon Monoxide Alarms Procedure Installation ProcedureSurface Wiring Ei220EN Only Testing with Carbon Monoxide Testing Your CO AlarmMaintaining Your CO Alarm How to disconnect and remove the alarm END of LifeProduct Disposal Limitations of CO Alarms B15584-R0-225EN&220EN-U&C 6/9/07 813 AM HOW to Protect Your Family B15584-R0-225EN&220EN-U&C 6/9/07 813 AM Technical Specification Sensor fault is found Guarantee Getting the CO Alarm ServicedB15584-R0-225EN&220EN-U&C 6/9/07 813 AM Alarm Sounds for no Apparent Reason TroubleshootingAlarm does not Work with the Test Button Alarm Beeps and Amber Light Flashes Every 40 SecondsRED and Amber Lights Flash TEST/HUSH Button does not Silence AlarmsEi Electronics Product Disposal