1. Install the Air Deflector | • |
Open the bottom front panel by lifting and pulling it away from the appliance. Attach the air deflector and green ground wire with two screws to the front of the blower output. See Figure 1.
Air
Deflector
Figure 1 Install Air Deflector
If the fan is being installed in a
|
|
Figure 4 | Fan Shield |
|
|
Note: Novus appliances do not require the use of the air deflector. Attach the green ground wire with the screw in the existing hole.
2. Install the Fan Bracket & Shield
•Place the fan bracket around the fan. See Figure 2.
Figure 2 Fan Bracket-No screws
•Install the two screws through the fan bracket into the back of the fan housing to hold the bracket in place. See Figure 3.
Figure 3 Insert Screws
•If no fan shield is needed, install screws to hold the front of the fan bracket in place. See Figure 5.
|
|
Figure 5 | Fan Bracket |
|
|
•Attach the foam tape (Figure 3) and magnets (Figure
6)to the fan. Cut one magnet strip in half and save the remaining strip for control module.
|
|
Figure 6 | Magnets |
2 | Hearth & Home Technologies • GFK4B Fan Kit • |