Niles Audio CM6HDFX manual Listening AT Higher Volumes, Cleaning, Operation, Specifications

Page 21

playing together will be lacking in bass and sound “phasey.” If you suspect the sound is not right, and you cannot see any markings on the wire, try this simple test:

1.Stand halfway between the speakers.

2.Play some music with the amplifier or radio set to Mono.

3.Listen to the richness of the bass and the loudness of the sound.

4.Turn off the amplifier and reverse the connections on one amplifier channel only.

5.Repeat the listening test with the same volume control setting. When the sound has a richer bass and is slightly louder, the speakers are working together or “in-phase.”

OPERATION

LISTENING AT HIGHER VOLUMES

Achieving a reasonable volume of sound in a large room requires more amplifier power than it does in a small room. It is possible to turn the volume up so high that the amplifier runs out of power. This creates “clipping” distortion, which will make treble sound very harsh and unmusical.

When you hear harsh-sounding treble from any good speaker, turn the volume down immediately! Those harsh sounds are masking much more powerful ultra-high-frequency sound spikes, which will quickly damage any fine loudspeaker. You are much less likely to damage a speaker driven by a large amplifier because it will be very loud before any clipping distortion is produced.

CLEANING

Clean the Niles CM6HDfx loudspeaker with a dampened soft cloth or paper towel. If the speaker is mounted high up on a wall or ceiling, use a broom to gently brush it off.

SPECIFICATIONS

Recommended Amplifier Power

Nominal Impedance

10 to 125 watts per channel

8 ohms

Frequency Response

Overall Exterior Dimensions

60 Hz to 21 kHz, +/- 3 dB (on axis)

9-1/4" diameter

 

 

(CONTINUED ON NEXT PAGE)

NILES AUDIO CORPORATION – 1-800-BUY-HIFI

 

 

19

 

 

Image 21
Contents CM6HDFX NEWCONGRATULATIONS!CONSTRUCTION Table of ContentsFeatures and Benefits DIRECT/DIFFUSE SettingINJECTION-MOLDED TCC Woofer with BUTYL-RUBBER Surround IntroductionEasy Installation INSTALLER-SELECTABLE Acoustic Fine TuningMicroperf Aluminum Grilles HOLE-SAVING BracketMounting a CM6HDfx loudspeaker into a ceiling Installation ConsiderationsRecommended Amplifier Power Tools and PrecautionsPlacement for Home Theater Rear Applications Loudspeaker WireSpeaker Placement Insulation Behind the SpeakerTweeters fire across Place CM6HDfx so tweeters fire along side wall Boundary Effect Using the Direct RADIATING/DIFFUSE Field Selector SwitchRunning the Speaker Wire in NEW Construction Using the Tweeter Level ControlInstallation Fundamentals Observe Safety FirstAbout Drilling Scheduling and PreparationConcealing Speaker Wire Pulling the CableAbout Interior Walls About Exterior Walls Planning the Speaker Wire RouteUnder-the-carpet runs using flat speaker wires Other Possible Speaker Wire Routes IncludeInsulating the Ceiling Cavity Mounting the NEW Construction BracketCutting Holes Concealing Speaker Wire for a Future Installation Installing the BracketPlanning the Installation Finishing the Installation Installing the SpeakersPainting the Speakers Checking Speaker PhaseCleaning Listening AT Higher VolumesSpecifications OperationLimited Warranty Telephone Warranty Registration CardL e s a u d i o C o r p o r a t i o n