Niles Audio CM6HDFX manual Tweeters fire across

Page 8

PLACEMENT FOR HOME THEATER REAR APPLICATIONS

(CONTINUED)

soundtrack to create desired effects. However, in a home with a single pair of front speakers, this surround effect will be lost, and jungle sounds may actually sound like they are emanating “from the middle of your head,” just like headphones!

A single pair of CM6HDfx Loudspeakers, properly placed, can create a very convincing simulation of an array of surround speakers. Here are some recommended placement tips:

Place the surround speakers near a hard reflecting surface, as shown in Figure 2. The reflections will help one pair of speakers to sound like several. If possible, try placing them near a corner (so that the adjoining walls will act as a powerful reflector) to create even more reflections, as shown in Figures 3 and 4.

Figure 2. CM6HDfx loudspeakers placed near a back wall of a home theater room.

Place CM6HDfx so

 

 

 

Place CM6HDfx so

tweeters fire across

 

 

 

tweeters fire across

back of room.

 

 

 

back of room.

Place CM6HDfx

Place CM6HDfx

so tweeters fire

so tweeters fire

toward walls.

toward walls.

Figure 3. CM6HDfx loudspeakers placed near back corner walls of a home theater room.

6

Place CM6HDfx

so tweeters fire

toward walls.

Place CM6HDfx

so tweeters fire

toward walls.

Figure 4. CM6HDfx loudspeakers placed near back corner walls of a home theater room with an L-shaped sofa.

Image 8
Contents CM6HDFX Table of Contents NEWCONGRATULATIONS!CONSTRUCTIONDIRECT/DIFFUSE Setting Features and BenefitsINJECTION-MOLDED TCC Woofer with BUTYL-RUBBER Surround IntroductionINSTALLER-SELECTABLE Acoustic Fine Tuning Easy InstallationMicroperf Aluminum Grilles HOLE-SAVING BracketInstallation Considerations Mounting a CM6HDfx loudspeaker into a ceilingTools and Precautions Recommended Amplifier PowerLoudspeaker Wire Placement for Home Theater Rear ApplicationsSpeaker Placement Insulation Behind the SpeakerTweeters fire across Place CM6HDfx so tweeters fire along side wall Using the Direct RADIATING/DIFFUSE Field Selector Switch Boundary EffectUsing the Tweeter Level Control Running the Speaker Wire in NEW ConstructionInstallation Fundamentals Observe Safety FirstScheduling and Preparation About DrillingAbout Interior Walls Concealing Speaker WirePulling the Cable Planning the Speaker Wire Route About Exterior WallsOther Possible Speaker Wire Routes Include Under-the-carpet runs using flat speaker wiresCutting Holes Insulating the Ceiling CavityMounting the NEW Construction Bracket Installing the Bracket Concealing Speaker Wire for a Future InstallationPlanning the Installation Installing the Speakers Finishing the InstallationChecking Speaker Phase Painting the SpeakersListening AT Higher Volumes CleaningSpecifications OperationLimited Warranty Warranty Registration Card TelephoneL e s a u d i o C o r p o r a t i o n