Niles Audio CM6HDFX Installing the Bracket, Concealing Speaker Wire for a Future Installation

Page 17

INSTALLING THE BRACKET

1.Attach the QuickSnap™ new-construction wings to the bracket by snapping them into the bracket sides. If the length will interfere with corner or eaves, you can shorten the wings by breaking them along the scored lines.

NOTE: THE WINGS AND BRACKETS HAVE CENTERING LINES TO SIMPLIFY PLACEMENT OF THE SPEAKERS.

2.Screw one side of the assembled bracket with wings to the joist, using one of the supplied screws. Level the bracket, and then screw the other side of the bracket/wing assembly to the joist. Two screws on each side make for a very secure installation.

3.Secure the wire to the bracket using bracket’s wire tie. The drywall installers will cut the drywall to the exact size of the bracket, as shown in Figure 14.

Figure 14. The optional hole- saving brackets are installed, and the speaker wire is attached to the bracket.

CONCEALING SPEAKER WIRE FOR A FUTURE INSTALLATION

1.Attach the speaker wire in a loop between the ceiling joists and carefully mark the exact location of the wire on a set of plans.

2.Ask the general contractor to inform the drywall installers that the speaker wire loops are concealed for future installations, as shown in Figure 15.

Figure 15. The speaker wire is looped and hung on two nails attached to the joists, securing it for future use. Be sure to note the location on house plans.

NILES AUDIO CORPORATION – 1-800-BUY-HIFI

 

15

 

Image 17
Contents CM6HDFX NEWCONGRATULATIONS!CONSTRUCTION Table of ContentsFeatures and Benefits DIRECT/DIFFUSE SettingINJECTION-MOLDED TCC Woofer with BUTYL-RUBBER Surround IntroductionEasy Installation INSTALLER-SELECTABLE Acoustic Fine TuningMicroperf Aluminum Grilles HOLE-SAVING BracketMounting a CM6HDfx loudspeaker into a ceiling Installation ConsiderationsRecommended Amplifier Power Tools and PrecautionsPlacement for Home Theater Rear Applications Loudspeaker WireSpeaker Placement Insulation Behind the SpeakerTweeters fire across Place CM6HDfx so tweeters fire along side wall Boundary Effect Using the Direct RADIATING/DIFFUSE Field Selector SwitchRunning the Speaker Wire in NEW Construction Using the Tweeter Level ControlInstallation Fundamentals Observe Safety FirstAbout Drilling Scheduling and PreparationAbout Interior Walls Concealing Speaker WirePulling the Cable About Exterior Walls Planning the Speaker Wire RouteUnder-the-carpet runs using flat speaker wires Other Possible Speaker Wire Routes IncludeCutting Holes Insulating the Ceiling CavityMounting the NEW Construction Bracket Concealing Speaker Wire for a Future Installation Installing the BracketPlanning the Installation Finishing the Installation Installing the SpeakersPainting the Speakers Checking Speaker PhaseCleaning Listening AT Higher VolumesSpecifications OperationLimited Warranty Telephone Warranty Registration CardL e s a u d i o C o r p o r a t i o n