Hearth and Home Technologies CF550EV Hand Held Remote Control Transmitter RCE-HNG Optional

Hearth & Home Technologies Inc. 800 W.

Jefferson, Lake City, MN 55041.

2.Hand Held Remote Control Transmitter - RCE-HNG (Optional)

a.The RCE-HNG is an optional accessory listed with the Crestfire Series appliances.

b.The transmitter is a radio frequency remote control. The frequency can be found on the back side of the transmitter. The range of the transmitter is approximately 20’ from appliance.

c.When the remote LED light is RED, the appliance has been turned on or off by the remote transmitter. The manual controls located on the dashboard will override any other external controls (remote control/wall switch) used to operate the appliance.

d.Hand Held Remote Transmitter/Appliance Initialization

1)The transmitter operates on a 12V battery (included) made specifically for remote controls and electronic lighters. Install the 12V battery supplied with the appliance into the battery compartment of the hand held remote transmitter. It is recommended that alkaline batteries always be used for longer battery life and maximum operational performance. If the signal light does not illuminate (when it normally would), check the position of the transmitter’s battery.

2)Initialization only has to be done once.

Note: If you lose power during operation or by turning the main power switch to “OFF”, the appliance will need to be reset. To reset the appliance, make sure that you have power to the appliance and the main power switch is in the “ON” position. Turn the flame switch off and on to reset the appliance.

3)Turn the main power switch on and then turn the flame switch on.

4)Locate the LEARN button on the dashboard. The LEARN button is located behind the lower grille/panel. To push the button, use a blunt object (such as a pencil).

5)Push the button in and release. The remote LED light should blink green. The remote LED light is located above the main power switch.

6)Push and hold either the ON or OFF button on the hand held remote transmitter. The remote LED light should begin to blink rapidly.

7)Release the button on the hand held remote transmitter and the remote LED light should stop blinking green and go out. This indicates that the transmitter and appliance are initialized. If the remote LED light turns red, the hand held remote transmitter is active.

8)The hand held remote transmitter is ready to be used.

WARNING!

Changes or modifications to this device not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.