![](/images/new-backgrounds/1010299/1029911x1.webp)
Hearth & Home Technologies Inc. 800 W.
Jefferson, Lake City, MN 55041.
E. INSTALLATION
Select a suitable location that is not susceptible to moisture and is away from drapes, furniture and high traffic areas.
If installing the appliance on/over carpeting, the appliance must be installed on a wood or metal panel extending the full width and depth of the appliance.
Note: Follow all national and local electrical codes.
1.Wall Cabinet Kit, Corner Cabinet Kit or Custom Cabinet Installation
*If the power cord is to be used, the Cabinet must provide access to the wall outlet.*
a.For ease of electrical hookup, you may wish to install the appliance near an existing outlet. A 15 amp, 120 volt circuit is required. A dedicated circuit is preferred but not essential in all cases. A dedicated circuit will be required if, after installation, the circuit trips or fuse blows on a regular basis while the appliance is operating. Additional appliances on the same circuit may exceed the current rating of the circuit breaker.
b.If using a listed wall cabinet or corner cabinet, refer to the installation instructions supplied with the kit. For custom cabinets, frame and construct with the opening and depth dimensions listed in Figures 1 and 2.
c.Before plugging the appliance into the wall outlet, make sure all control switches are in the “OFF” position. Open the lower grille panel to gain access to the controls.
d.Before finishing the cabinet, the appliance must be set into the cabinet and the power cord routed to the electrical outlet. If the power cord is not being used, refer to Section “F. Wiring” for hard wiring instructions. If the power cord does not reach the outlet, a No.
e.To complete the appliance installation, refer to Section “H. Final Installation”.
2.Non-Cabinet or Chase Installation
a.Follow recommended framing dimensions in Figures 1 and 2.
b.Set the appliance into the framed opening. Secure the appliance in place by bending out the two nailing flanges on both sides of the appliance and nail to the framing. The nailing flanges have been positioned 5/8” back from the front of the appliance to allow for the addition of drywall.
c.Wiring instructions for 120/208/240V can be found in Section “F. Wiring”. The power cord must be removed and appliance be hardwired in all
d.Remove the protective cover before finishing the front of the appliance. To finish out the appliance, follow the instructions found in Section “G. Finishing”.
e.To complete appliance installation, see Section “H. Final Installation”.
WARNING - RISK OF FIRE!
The power cord must not be pinched or against a sharp edge. Secure cord to avoid tripping or snagging to reduce the risk of fire, electric shock or personal in- jury.
Do not run cord under carpeting. Do not cover cord with throw rugs, runners or the like. Arrange cord away from traffic areas and where it will not be tripped over.
WARNING - RISK OF FIRE!
To prevent a possible fire, do not block air intake or exhaust in any manner. Do not use on soft surfaces (like a bed) where openings may become blocked.
CAUTION:
When transporting or storing this appliance and cord, keep in a dry place that is free from excessive vibration. Store so as to avoid damage.
10/03
CRESTFIRE SERIES ELECTRIC FIREPLACE | 6 |