Hearth and Home Technologies BV4236DBI manual Lighting Instructions IPI, Final inspection by

Page 11

L. Lighting Instructions (IPI)

FOR YOUR SAFETY

READ BEFORE LIGHTING

WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.

LIGHTING

INSTRUCTIONS (IPI)

1. This appliance is equipped with an ignition

device which automatically lights the burner.

DO NOT try to light the burner by hand.

A. This appliance is equipped with an intermittent pilot ignition (IPI) device which automatically lights the burn- er. DO NOT try to light the burner by hand.

B.BEFORE LIGHTING, smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.

WHAT TO DO IF YOU SMELL GAS

•DO NOT try to light any appliance.

•DO NOT touch any electric switch; do not use any phone in your building.

•Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.

•If you cannot reach your gas sup- plier, call the fire department.

C. DO NOT use this appliance if any part has been under water. Imme- diately call a qualified service tech- nician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.

GAS

VALVE

2.

Wait five (5) minutes to clear out any gas.

 

Then smell for gas, including near the floor. If

 

you smell gas, STOP! Follow “B” in the Safety

 

Information located on the left side of this la-

 

bel. If you do not smell gas, go to next step.

3.

To light the burner:

 

Equipped with wall switch: Turn ON/OFF switch

 

to ON.

 

 

 

 

 

WARNING:

 

CAUTION:

 

DO NOT CONNECT LINE VOLT-

Hot while in operation. DO NOT touch.

AGE (110/120 VAC OR 220/240

Keep children, clothing, furniture, gaso-

VAC) TO THE CONTROL VALVE.

line and other liquids having flammable

Improper installation, adjustment, al-

vapors away.

DO NOT operate the appliance with

teration, service or maintenance can

fixed glass assembly removed, cracked

cause injury or property damage. Re-

or broken. Replacement of the fixed

fer to the owner’s information manual

glass assembly should be done by a

provided with this appliance.

licensed or qualified service person.

This appliance needs fresh air for

 

 

 

safe operation and must be installed

NOT FOR USE

 

so there are provisions for adequate

WITH SOLID FUEL

 

combustion and ventilation air.

 

If not installed, operated, and main-

For use with natural gas and propane.

tained in accordance with the manufac-

A conversion kit, as supplied by the

turer’s instructions, this product could

manufacturer, shall be used to convert

expose you to substances in fuel or

this appliance to the alternate fuel.

fuel combustion which are known to the

Also Certified for Installation in a

State of California to cause cancer, birth

Bedroom or a Bedsitting Room.

defects, or other reproductive harm.

For assistance or additional informa-

Keep burner and control compartment

tion, consult a qualified installer, ser-

clean. See installation and operating

vice agency or the gas supplier.

instructions accompanying appliance.

 

 

 

For additional information on operating your

Hearth & Home Technologies fireplace, please refer to www.fireplaces.com.

Final inspection by

Equipped with remote or wall control: Press

ON or FLAME button.

Equipped with thermostat: Set temperature to

desired setting.

4. If the appliance does not light after three tries,

call your service technician or gas supplier.

TO TURN OFF

GAS TO APPLIANCE

1.Equipped with wall switch: Turn ON/OFF switch to OFF.

Equipped with remote or wall control: Press OFF button.

Equipped with thermostat: Set temperature to lowest setting.

2.Service technician should turn off electric power to the control when performing service.

593-913G

Hearth & Home Technologies • BV4236DBI, BV4842DBI • 2209-900 Rev. N • 9/12

11

Page 10 Page 12
Image 11
Page 10 Page 12
Contents Do Discardnot What to do if you smell gasXxxxxxxx CongratulationsHomeowner Reference Information User Guide Table of ContentsReference Materials TroubleshootingLimited Lifetime Warranty Limited Lifetime Warranty Hearth & Home Technologies IncWarranty Conditions Limited Lifetime WarrantyListing and Code Approvals Your Fireplace Gas Fireplace SafetyOperating Instructions User Guide Fan Kit optional Fixed Glass AssemblyRemote Controls, Wall Controls and Wall Switches IPI Battery Tray/Battery InstallationBefore Lighting Fireplace Module ResetNine Hour Safety Shutdown Feature Control Module OperationAGE 110/120 VAC or 220/240 Lighting Instructions IPIFinal inspection by Do not Connect Line VoltAfter Fireplace is Lit Frequently Asked QuestionsMaintenance and Service Firebox Maintenance Tasks-Qualified Service TechnicianGasket Seal and Glass Assembly Inspection LogsCover Plates Lava Rock Basket, Grate and Valve As- sembly RemovalBurner Identification/Verification Typical Appliance System Getting StartedInspect Appliance and Components Design and Installation ConsiderationsTools and Supplies Needed Negative Pressure BV4842DBI Framing and ClearancesSelecting Appliance Location BV4236DBIConstructing the Appliance Chase Minimum Framing DimensionsCombustible Mantels Clearances Mantel and Wall ProjectionsVent Termination Minimum Clearances Termination LocationsVent Guidelines Vent Information and DiagramsVertical Penetration Framing Vent Clearances and FramingPipe Clearances to Combustibles Wall and Ceiling Penetration FramingGas and Electrical Connections Installing Outside Air Kit Damper Assem- blyInstalling the Non-combustible Board Appliance PreparationProper Positioning, Leveling And Securing Of An Securing and Leveling the ApplianceAttaching Vent to Firebox Installing Vent PipeAssembly of Vent Sections Install Attic Insulation ShieldGas Connection Gas InformationFuel Conversion Gas PressureElectrical Information Wiring RequirementsIntelliFire Plus Ignition System Wiring Optional Accessories RequirementsElectrical Service and Repair Junction Box Wired to Wall Switch or BC10 Wall Switch Installation for Fan OptionalCombustible Mantel Legs or Wall Projections FinishingFacing Material Finishing Material Thickness 1 Inch Thick or Less DoorsFinishing Material Finishing Material Thickness Greater Than One Inch AnyAttaching Finishing Strips Attachment of Finishing StripsAppliance Setup Placement of Embers Ember PlacementLeft Grate Tine Install the Log Assembly Log Assembly LOGS-BV36LOG Placement Tabs LOG Placement Indentations Grate Tine LOG Placement Slots LOG Placement TabsFlat Area LOG #6 Contacts TOP of LOG #4 Right Grate TineLOG Nose Slots Grooves Left Grate Tine Install the Log AssemblyLOG Placement Indentations LOG Placement Tabs Grate Tine LOG #4 Contacts LOG #2 Horizontal Grate BARAir Shutter Settings Install Trim and/or SurroundAir Shutter Setting IntelliFire Plus Ignition System TroubleshootingSymptom Possible Cause Corrective Action Burner will not ignite Reference Materials Appliance Dimension DiagramCatalog # BV4236DBI BV4842DBI BV4236DBI , BV4842DBI Sold as Kit Only Contact Information

BV4236DBI specifications

The Hearth and Home Technologies BV4236DBI is a stunning direct vent gas fireplace that combines elegance with cutting-edge technology. Designed to enhance any living space, this fireplace provides a perfect blend of aesthetics and functionality, ensuring warmth and comfort during chilly evenings.

One of the standout features of the BV4236DBI is its contemporary design that offers a wide viewing area for the mesmerizing flames. With a sleek front and minimalistic frame, it fits seamlessly into modern home decor, making it an attractive focal point in any room. The large, unobstructed glass allows for maximum visibility of the fire, providing a cozy ambiance.

Performance-wise, the BV4236DBI boasts an impressive heating capacity. With a BTU output of up to 36,000, it effectively warms spaces ranging from medium to large. The efficiency of this fireplace ensures not only warmth but also reduced energy costs, making it an economical choice.

The BV4236DBI features advanced venting technology that allows for installation flexibility. The direct vent design draws air from the outside for combustion, ensuring that indoor air quality remains unaffected. This setup minimizes heat loss and creates a safe environment for users, making it suitable for homes of all types.

Another notable characteristic is the intuitive remote control and optional wall switch. This convenience feature allows users to easily adjust the flame height and heat output from anywhere in the room, ensuring customized comfort at the touch of a button. Additionally, the fireplace is equipped with an adjustable flame and media options, including decorative crushed glass or ceramic logs, which enhance the visual appeal.

Safety is a priority, and the BV4236DBI incorporates several safety features such as a built-in safety shutoff and an optional screen to prevent potential hazards. The fireplace's durable construction meets stringent safety standards, providing peace of mind for families.

In summary, the Hearth and Home Technologies BV4236DBI is a versatile, stylish, and efficient gas fireplace that offers an unmatched home heating experience. With its powerful performance, elegant design, and advanced technologies, it stands out as a prime choice for homeowners looking to elevate their living spaces with both comfort and sophistication. Whether for a cozy evening or a lively gathering, this fireplace provides the warmth and ambiance that every home deserves.
Top Page Image Contents