I SECTION 4 I WATER FILTER TIMER/RECHARGE SETUP | I |
1• SET THE TIMER
After the transformer is plugged into the elec- tricaL ouUet (step 13, page 14), 12:00 AM SUnday
began to flash in the time display, Set the time of day, present day of week, days and/or time of recharge.
A. SET TIME OF DAY
1.Press the PRESENT TIME AND DAY button [] once. The hour display flashes.
2.Press the SET/CLEAR button [] until the present hour of the day shows in the display. Be sure AM for morning hours, or PM for afternoon and even- ing hours shows.
NOTE: Press button [] and quickly release to move the hour display ahead I at a time to the correct hour. Or, hold button [] to move the display ahead 2 hours each second, to the correct hour.
B. SET PRESENT DAY OF WEEK
1.Press the SET/CLEAR button [] to set the pre- sent day of the week in the display.
NOTE: Press button [] and quickly release to move the day display 1 at a time. Or, hold button [] to move
C, SET DAYS OF RECHARGE (BACKWASH)-
NOTE, IF YOU HAVE A WATER SOFTENER OR OTHER AUTOMATIC FILTER: A good water flow rate is needed for proper recharging and/or backwashing of all water conditioners. To help assure good water flow, you should offset the timers on each conditioner
so recharges do not occur on the same days, or at the same time.
...Most Sears water softeners are factory set (many are adjustable) to recharge from 2:00 to 4:00 AM.
...Set the clarifying filter to recharge on different
days, or...
...Set the clarifying filter to recharge either 2 hours
before or after other equipment, or...
...Offset the timers on all equipment to beqin re- charging at 12:00, 2:00 and 4:00 AM, or 1:00, 3:00 and 5:00 AM, etc.
displaybuttons
/
3.Press button [] once to steady the hour display, and minutes begin to flash. Repeat step 2 to set the correct minutes,
4.Press button [] again to steady the minute dis-
play (day will begin flashing). Figure 15 shows the timer set at 3:30 PM.
the day display ahead 2 days each second.
2.Press button [] again to steady the entire display. Figure 15 shows the timer set at TUesday.
1.Read, "HOW OFTEN SHOULD YOU RECHARGE (BACKWASH) THE FILTER", page 16.
NOTE: The timer is factory programmed to recharge on Monday, Wednesday and Saturday.
2.Press the RECHARGE DAY button [] and SUnday begins to flash.
...if you want recharges on Sunday (from table), press the SET/CLEAR button [] to display ON.
...If you do not want Sunday recharges, press button [] to display OFF.
3.Press button [] again to display a flashing MOnday. As you did in step 2 above, press button [] to display ON for recharge on Monday, or OFF for no recharge on Monday.
continued
15.