I SECTION 3 I STEP BY STEP GUIDES TO INSTALL
| Close the | Shutoff | Shutofl | Pressure |
• I. |
| |||
pipe, near the water meter or pressure tank, to Valve | Valve | Tank | ||
turn | off the water. |
|
|
|
|
| Meter | Pump | I' |
•3. Open the highest and lowest water faucets in your house to let water drain from the pipes.
Close faucets after water has drained.
Take all the small parts from the parts bag and
4.lay out neatly where you can easily see and get to them as they are needud.
NOTE: The inlet screen is not used on the clarifying filter, and can be discarded.
Electrical
Gas
Valve
Panel
SMALL PARTS BAG ITEMS
(_) SCREENINLET _'_ _ADAPTORNLET-OUTLET(2) CLIP (2)
GROUND
CLAMP (2) | _ I] NLET.OUTLET |
___________ | TUBE (2) |
TRANSFORMER
_INL_r-OUTLE¢
_ _ NUT (2)
® _ GROUNDWIRE,
_, Q= SCREWS AND NUTS
5, INSTALL INLET AND OUTLET ADAPTORS OR
SEARS BYPASS VALVE, ITEM NO.
NOTE: If you will install the bypass valve, the adap- tors are not used. If you do not install the bypass valve, you must use the adaptors.
INLET AND OUTLET ADAPTORS (Adaptors am and clips are small parts bag items.) - Push the
adaptors into the valve inlet and outlet ports (FIG. 5 and 7) as far as they will go. Both adap- tors are the same and fit either valve port. SNAP
THE 2 LARGE HOLDING CLIPS INTO PLACE, FROM THE TOP DOWN AS SHOWN. BE SURE THEY SNAP FIRMLY INTO PLACE, SO THE
ADAPTORS WILL NOT PULL OUT...GO TO STEP 6.
INSTALLING INLET AND OUTLET
ADAPTORS OR BYPASS VALVE
Clips (2)
| Adaptors |
SEALS | //4 |
PLACED tN | OR |
ONLY. CLIP SNAPS | P/ |
INTO INNER GROOVES |
|
(SEE FIG. 7) |
|
9